D2 Chassis Advice (photos)

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
A

Adam90

Member
Posts
11
Location
Keswick
Hi all!

It’s been a long time since I was on the forums, so hello again. I had a terrible time with a 90 a few years ago, but back again looking at D2’s.

I’ve found what I think is a good one, everything looks great, service history is fantastic and mot history is also great. Condition looks good, but the only thing I’m not sure on is the rear chassis. I’ve attached a few pictures, could anyone advise whether it looks ok and just surface type rust; or, is it something a bit more rotten. The vehicles a few hours away so hoping someone could give me some feedback based on the photos, it’d be massively appreciated.

It’s at the higher end of the price bracket, so don’t want to spend on something that’s going to bite me in the butt in a big way with a chassis fix/replacement.

Thanks in advance,
Adam
 

Attachments

  • AE90F0FE-EB29-4ECE-AC6C-5BA03A1A06D3.jpeg
    AE90F0FE-EB29-4ECE-AC6C-5BA03A1A06D3.jpeg
    138.4 KB · Views: 192
  • 1E9B4D3E-6107-47E2-903D-E626C73819FB.jpeg
    1E9B4D3E-6107-47E2-903D-E626C73819FB.jpeg
    90.9 KB · Views: 204
  • 5225E56C-596B-488F-B917-7AF06B9D8E3C.jpeg
    5225E56C-596B-488F-B917-7AF06B9D8E3C.jpeg
    124.6 KB · Views: 199
Last edited:
Need to check inside edge against fuel tank, but that is a common repair. Couple hundred in a garage so not too bad worst case.

If you can poke through on side by tank, either knock a couple hundred off or walk away.

What is it like nearer the ARB brackets? Is that solid?
 
MJI said:
Need to check inside edge against fuel tank, but that is a common repair. Couple hundred in a garage so not too bad worst case.

If you can poke through on side by tank, either knock a couple hundred off or walk away.

What is it like nearer the ARB brackets? Is that solid?
Click to expand...

thank you. I’m not sure on the area by the ARB brackets, I’m going fully of pictures so far so trying to decide whether it’s worth the 6 hour round trip or not based on that at the moment.
 
Adam90 said:
thank you. I’m not sure on the area by the ARB brackets, I’m going fully of pictures so far so trying to decide whether it’s worth the 6 hour round trip or not based on that at the moment.
Click to expand...

Can you zoom in on the last pic ?

It looks like a crack in the chassis side / bottom junction, I can't tell properly as I a bit under the weather at the moment and my head is not right ..
 
as stated earlier, the bit you cant see the inside were the fuel tank is is a problem spot, it where the MOT tester knocked a big hole in mine, not sure how as I could do it with my hammer which is a lot bigger than and MOT hammer
 
Where is the vehicle ? perhaps find a vehicle inspector in that area - might be worth it to confirm chassis condition...

I agree with Dippy, that the area in question doesn't look "right" - but it is very hard to say from a photo - needs a knock test from LR #1 special tool ;)

The other problem spot is where the rear dampers mount onto the chassis - can you get pics of this area ?
 
Adam90 said:
Hi all!

It’s been a long time since I was on the forums, so hello again. I had a terrible time with a 90 a few years ago, but back again looking at D2’s.

I’ve found what I think is a good one, everything looks great, service history is fantastic and mot history is also great. Condition looks good, but the only thing I’m not sure on is the rear chassis. I’ve attached a few pictures, could anyone advise whether it looks ok and just surface type rust; or, is it something a bit more rotten. The vehicles a few hours away so hoping someone could give me some feedback based on the photos, it’d be massively appreciated.

It’s at the higher end of the price bracket, so don’t want to spend on something that’s going to bite me in the butt in a big way with a chassis fix/replacement.

Thanks in advance,
Adam
Click to expand...
 
That actually doesn't look too bad. Mine got a lot worse before I had it properly repaired.
BUT, it can go from not looking too bad to being really bad very suddenly.
If it is not too pricey I'd say buy it and bargain on having to have it repaired later on and rust treating it to hell as soon as you get it.
Just my 4 pennorth.
 
Stanleysteamer said:
That actually doesn't look too bad. Mine got a lot worse before I had it properly repaired.
BUT, it can go from not looking too bad to being really bad very suddenly.
If it is not too pricey I'd say buy it and bargain on having to have it repaired later on and rust treating it to hell as soon as you get it.
Just my 4 pennorth.
Click to expand...
Agreed, looks pretty good to me.
Tank off and a bit of a paint and waxoyl and its good for many years.
 
Thank you all for the advice and input, that’s really helpful. It’s been looked after by a Land Rover specialists so am going to see if they and the buyer will agree to an inspection at my cost prior to purchase. Seller seems very genuine and has given more info than I’ve requested and it’s got a stack of service history and repairs in their ownership, so if the chassis is good, fingers crossed it’ll be mine!
 
Adam90 said:
Thank you all for the advice and input, that’s really helpful. It’s been looked after by a Land Rover specialists so am going to see if they and the buyer will agree to an inspection at my cost prior to purchase. Seller seems very genuine and has given more info than I’ve requested and it’s got a stack of service history and repairs in their ownership, so if the chassis is good, fingers crossed it’ll be mine!
Click to expand...
Sounds very good, best of luck with it.
There are loads of peeps on here who have them, love them and know how to fix them. I bought mine out of necessity, in a bit of a hurry but have grown to love it too, though my heart still belongs really to my D1 Annie!:):):)
 
  • Like
Reactions: MJI
Get the owner to put it through an MOT test for you... that will highlight any concerns. Paying £40 upfront to the owner will save that 6 hour round trip if it fails.
 
So, some advice on one I’ve just viewed. Mechanically, it’s is extremely good. The rear chassis has some what appears to be very old under seal on, which has either cracked, or the chassis has. The areas where the under seal has flaked off (not many), or the bits a peeled off looks solid. But, would you be concerned about the attached photos. It looks to me like thick undersell that’s cracked, but I’m not expert.
 

Attachments

  • 486B0D1B-C97E-4380-BCB7-8752F1F74CD1.jpeg
    486B0D1B-C97E-4380-BCB7-8752F1F74CD1.jpeg
    54.6 KB · Views: 126
  • CFDBF646-D35F-4CC7-A247-5A15BFFECFCF.jpeg
    CFDBF646-D35F-4CC7-A247-5A15BFFECFCF.jpeg
    298.5 KB · Views: 119
  • DEF20B0C-93C0-4F28-A71D-C2CE85CBF186.jpeg
    DEF20B0C-93C0-4F28-A71D-C2CE85CBF186.jpeg
    51.3 KB · Views: 149
Adam90 said:
So, some advice on one I’ve just viewed. Mechanically, it’s is extremely good. The rear chassis has some what appears to be very old under seal on, which has either cracked, or the chassis has. The areas where the under seal has flaked off (not many), or the bits a peeled off looks solid. But, would you be concerned about the attached photos. It looks to me like thick undersell that’s cracked, but I’m not expert.
Click to expand...
You really have to go to it with overalls a good torch a small hammer and a screwdriver. do not be afraid to have a damn good poke and pry around.
I find it quite amusing handing big bits of rusty metal to the owner as I bang/pry them off. (Then of course I don't buy it!)
If the owner won't let you get under and do this, then walk away or offer him/her a price based on extensive chassis work being needed.
As a lot of us have said that one doesn't look bad at all, and I'd buy it provided I had been able to do what I just said. The last one I bought was a bit worse than that. Bought 2014 and lasted passing MOTs etc until I decided to get the rear chassis plated two years ago. Mind you I did get it properly done in thicker metal than the original and the rot cut out not just plated over.
If it's at the higher end of the price bracket you have to ensure everything works and we have to assume that it's an ES or summat i.e. top of the range.
 
It’s a gs, so not top of range and it’s fairly priced. He had no issues at all with me underneath, and I peeled a few bits off that I could and underneath what I could get off was fine, surface rust if anything, but no flaky bits at all. It’s never had an advisory for chassis on MoT, and has recently passed with no chassis advisory.
 
  • Like
Reactions: MJI
You must log in or register to reply here.

Similar threads

H
D2 ABS Sensors
Replies
3
Views
230
sierrafery
sierrafery
L
Disco 1 How were the Chassis’s originally painted?
Replies
10
Views
694
grewth
G
P38 guy
Bent chassis
Replies
13
Views
625
P38 guy
P38 guy
Sieklo
Disco 2 D2 TD5 Auto high fuel consumption
Replies
8
Views
476
sierrafery
sierrafery
D
Disco 2 D2 AAP question
Replies
9
Views
769
sierrafery
sierrafery
Back
Top