COMPLAINING BEARINGS -- SOLVED--

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
F

freespaña

Active Member
Posts
157
Location
España
Hi again guys.
I changed the cardan bearings because they were old, as soon as I put the new ones they make noise and vibrate a little at low speed. I have taken care to mount them well and at a 90º angle, I marked the washers and transfer to mount it in the same position. Could they be faulty or have I made a mistake? Help please I need your opinion if I should order another news. Thanks
 
Nodge68 said:
The flexible joints on the end of the drive shafts, which connect the drive shafts to the VCU splines.
Click to expand...


Sorry it seems I'm a bit clumsy. I don't know what joints you mean. I have already changed in others and I do not find anything different, it takes the screw and a U-shaped washer on each side of the VCU. I don't know if that's what you mean...
 
Ok. Thanks for the picture. I don`t know how to say you how is it... they are normal.
Before the change of central bearings there is no any noise.
 
You must log in or register to reply here.

Similar threads

Zorro587
Noise gone but prop shaft queries abound
Replies
14
Views
956
Chris_68
C
xDParis64
Hello Again! (SOLVED, Engine replacement)
2 3
Replies
56
Views
3K
xDParis64
xDParis64
tankduck
Stupid LT230 mistake!
Replies
8
Views
836
lynall
L
M
Sport ACE bypass for RR Sport 4.2 Petrol SC
Replies
10
Views
1K
mikesavva
M
D
Cruise control mind of its own
2
Replies
33
Views
2K
Graculus
Graculus
Back
Top