Series 3 Coil connections
- Thread starter TomSy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,027
- Location
- west wales coast
Power to positive on coil, negative connection goes to distributor. Without that nothing happens.
What's going on in your pic don't know, not enough info.
What's going on in your pic don't know, not enough info.
Last edited:
- Posts
- 33,599
- Location
- North Shropshire
If that's a stock photo from a book then it could be a power feed to thel heater on a solex carburettor. It gets activated when you pull the choke on
First picture was from a Series 3 manual, with 3 wires connected to the coil. This picture is my car with just one positive low tension connection and the other connectors vacant. Does it earth through the holding clamp or should it have a wire connection to negative on distributor?
Attachments
tottot
Well-Known Member
- Posts
- 8,027
- Location
- west wales coast
No earth. Read my post above again.
- Posts
- 33,599
- Location
- North Shropshire
If the coil was permanently earthed, ie through the body then it would never make a spark
Grounding the body can help reduce electrical noise from the coil and helps to sink heat away from the coil, maintaining efficiency
Grounding the body can help reduce electrical noise from the coil and helps to sink heat away from the coil, maintaining efficiency
Last edited:
Dorset_dumpling
Well-Known Member
- Posts
- 914
- Location
- Poole, UK
You should have two terminals on your coil. One will be marked + or sw and the other will be marked - or cb, Connect the + terminal to the wire from the ignition switch and connect the - terminal to the small lead on your distributor. If you have an electronic distributor you will have two leads, one red one and one black one. Connect the red lead to the + terminal on the coil with the ignition lead and the black one to the - terminal on the coil.
Thanks to all, being novice I confused HT with LT on wiring diagram. Now found the connector to distributor and problem solved, running sweetly
