clutch

hyland770 · Dec 30, 2008

Right im puzzled again...wats new!!! There is absolutely no resistance on the clutch pedal, if there were a breze it would flap in it, thats how loose it is. i tried to bleed it but that didnt work, there is fluid in the resevoir but it still wont bleed. The cylinder in the engine bay looks fine and there arent any leaks in the pipes, so i was wondering what else could it be!? does anyone have any ideas on how to fix this!? thanks for your help once again!

steve2286w · Dec 30, 2008

i would check the seals in the master cylinder and slave cylinder, look at the slave cylinder first as its easier to get to, the seals can turn to mush and hence loss of pressure, if it looks dodgy change both, new units are fairly cheap but if the bores are perfect you could just use a reseal kit

Jackual_NZ · Jan 2, 2009

when you were bleeding the system did you pump the pedal?

i always use a jam jar and some old clear pipe, keep pumping untill no air comes out, and the keep the pedal fully down and tighten up the bleed nut.

hyland770 · Jan 2, 2009

yeah i know how to do it, turns out its a seized master cylinder took the whole lot out today now just need to buy a new one, took me half a day to get one of the nuts off that holds the cylinder in place, was in the most stupid place lol not good. thanks for the help!

Jackual_NZ · Jan 2, 2009

ive been having problems with the clutch too. good thing is tho, i can bleed it all out in about 10 mins!

think the seals have gone in the master as sometimes fluid will run down the pedle, sounds like a baster of a job

cheers.

Tig9619 · Jan 2, 2009

its a very easy job if you take the pedal box out as you can get to the bottom bolt easier.

hyland770 · Jan 4, 2009

THAT FEKIN BOTTOM BOLT!!!! i decided the whole master cylinder needed to be replaced (the rod that goes into the bell housing of the cylinder is completely seized, and when i emptied the cylinder of oil, a lot of gunk came out) but that feking bottom bolt took me about half a day to get that off!!! gah, oh well at least i know what the problem is now!

G-man · Jan 4, 2009

you did take the pedal box out didn't you, it took me about an hour including a tea break and bleeding the fluid

Clipstone · Jan 4, 2009

hyland770 said:
THAT FEKIN BOTTOM BOLT!!!! i decided the whole master cylinder needed to be replaced (the rod that goes into the bell housing of the cylinder is completely seized, and when i emptied the cylinder of oil, a lot of gunk came out) but that feking bottom bolt took me about half a day to get that off!!! gah, oh well at least i know what the problem is now!

Funny you say this....have you looked at this months LRO mag????? A article on how to change the master clutch cylinder!!!!!!! Page 222

Also another on tuning a Series III carb!!!!!

clutch

hyland770

New Member

steve2286w

Well-Known Member

Jackual_NZ

New Member

hyland770

New Member

Jackual_NZ

New Member

Tig9619

Active Member

hyland770

New Member

G-man

BBQ king

Clipstone

New Member

Similar threads