Freelander 1 CLUTCH CHANGE 2002 TD4

fredi250 · Jan 22, 2018

Looking for any body with a how to with the short cuts not on Rave My daughter is stuck in a little village in spain a 100 klm away from a main town with a mechanic only used to doing small jobs and who has never worked on a freelander,
My daughter is not afraid of getting her hands dirty and can use a spanner, So will be able to help him needs to be able to look at some sort of how to , a scan of a haynes manual or something like would be much appreciated , I have new clutch kit being delivered to her as we speak But am limited as to what I can do as am layed up in Hospital at moment
Hope someone can help.

PS youtube is not much help at all

Thanks Freddie

jedi · Jan 22, 2018

Here you go buddy.

http://pmmonline.co.uk/technical/how-fit-clutch-land-rover-freelander/

fredi250 · Jan 23, 2018

Thanks Jedi not quite what I was looking for but it will help .
There is a way to remove without removing the IRD only removing nearside hub and driveshaft and thats what I really was looking for.as there very limited NO LIFT and will be doing the Job on the floor using just axle stands and ramps.
If any one has a haynes I think the process is in there.

guineafowl21 · Jan 23, 2018

I followed this guide, so can confirm it’s good: http://pmmonline.co.uk/technical/clutch-replacement-land-rover-freelander-2-0-td4/

I think you can do it without removing the IRD, but you’re better off doing so. I did mine with no lift, just axle stands and on my own so don’t panic.

fredi250 · Jan 24, 2018

Well parts just arrived and there going to go the route leaving IRD , My daughter has found a Polish vid that takes you through the whole process without the bells and whistles that Rave requires, that combined with some youtube stuff she thinks will see her and the local through.

deangermouse · Jan 24, 2018

Pretty sure that you have to remove the ird as there is a bolt holding the gearbox on behind it on the diesel models. Good luck

digby · Jan 24, 2018

I removed it’d to do mine

I thought leaving the odd would make aligning the gearbox to refit very difficult with the engine still in the car

Some say it would be easier to drop the engine - this would certainly make the job easier but you need a hoist of course ......

Freelander 1 CLUTCH CHANGE 2002 TD4

fredi250

Well-Known Member

jedi

Well-Known Member

fredi250

Well-Known Member

guineafowl21

Well-Known Member

fredi250

Well-Known Member

deangermouse

Active Member

digby

Active Member

Similar threads