BikerB
Well-Known Member
- Posts
- 6,313
- Location
- Far up North
I am just about to start thinking of getting the machining done on my six pot now I have most of the bits needed to reassemble it.
It was off the road for over 20 years and the coolant have leaked out/evaporated so the waterways inside the block are full of dried out rust, coolant flakes and salts and general muckiness.
What can I do or use to flush this all out before getting the machining done to avoid it all ending up in my nice new, and expensive, water pump?
It was off the road for over 20 years and the coolant have leaked out/evaporated so the waterways inside the block are full of dried out rust, coolant flakes and salts and general muckiness.
What can I do or use to flush this all out before getting the machining done to avoid it all ending up in my nice new, and expensive, water pump?
