norseman
Well-Known Member
- Posts
- 3,259
- Location
- Essex - UK
This one is driving both myself & my local garage nuts!
1987 Vouge 3.5EFI auto 63,000m.
Background >
Following a period of intermittent rough running back in the summer I replaced the following components:
Ignition coil, remote ign. amplifier (from Powerspark) plug leads & spark plugs, coolant temp. sensor (signal to ECU). Dizzy cap & rotor arm are of a far better quality (UK made Lucas) than the aftermarket replacements I originally purchased, so were cleaned/inspected & retained.
The car ran well for a short time, but then developed even worse symptoms & when I discovered that the V8 was only firing on just one bank I replaced the ECU with a unit I'd had re-conned a few years ago.
The car then ran better than it has ever done over the 15 years of my ownership, until 3 weeks ago when disaster struck.
Started the car from stone cold & after running at fast idle for a couple of minutes the engine just cut out. Turned off the key & attempted a restart, dashboard warning lights all light up & engine spins over freely (good battery) but will not even attempt to fire.
Garage investigated & found power to the input of the coil (primary circuit?) but nothing at the distributor. Coil substituted for a new one, same result. Spoke to Powerspark who were very helpful & suggested checking the air gap in the dizzy, passed that info. onto the garage this morning, but have yet to hear back from them.
Garage suggests trying another dizzy, makes sense but I don't have a spare & am understandably reluctant to spend £160 on an 'aftermarket' unit (OE is a fortune) just for an experiment.
nb. garage is a trusted family business that I have used for years, both for servicing/repairs & MOT's.
Any thoughts much appreciated guys.
1987 Vouge 3.5EFI auto 63,000m.
Background >
Following a period of intermittent rough running back in the summer I replaced the following components:
Ignition coil, remote ign. amplifier (from Powerspark) plug leads & spark plugs, coolant temp. sensor (signal to ECU). Dizzy cap & rotor arm are of a far better quality (UK made Lucas) than the aftermarket replacements I originally purchased, so were cleaned/inspected & retained.
The car ran well for a short time, but then developed even worse symptoms & when I discovered that the V8 was only firing on just one bank I replaced the ECU with a unit I'd had re-conned a few years ago.
The car then ran better than it has ever done over the 15 years of my ownership, until 3 weeks ago when disaster struck.
Started the car from stone cold & after running at fast idle for a couple of minutes the engine just cut out. Turned off the key & attempted a restart, dashboard warning lights all light up & engine spins over freely (good battery) but will not even attempt to fire.
Garage investigated & found power to the input of the coil (primary circuit?) but nothing at the distributor. Coil substituted for a new one, same result. Spoke to Powerspark who were very helpful & suggested checking the air gap in the dizzy, passed that info. onto the garage this morning, but have yet to hear back from them.
Garage suggests trying another dizzy, makes sense but I don't have a spare & am understandably reluctant to spend £160 on an 'aftermarket' unit (OE is a fortune) just for an experiment.
nb. garage is a trusted family business that I have used for years, both for servicing/repairs & MOT's.
Any thoughts much appreciated guys.