Chippie run party fund
- Thread starter blue beasty
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
Still available, £40+ delivery or lz courier can probably get it close to you if I take it to the chippie run
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
I've taken just taken the winch motor apart and it's all good apart from the isolator where the positive connection goes through the motor casing. Needs the brass bolt with the brushes brazed to tht goes through the isolator because it was damaged and is now snapped in two 
Someone could braze the brushes onto a new brass bolt cause the brushes and wire themselves are in good nick but I imagine you'd only save a few pennies.
The motor itself and bearings are in excellant condition
Will post up piccies when I get home
Someone could braze the brushes onto a new brass bolt cause the brushes and wire themselves are in good nick but I imagine you'd only save a few pennies.
The motor itself and bearings are in excellant condition
Will post up piccies when I get home
Paulmitchell1984
Well-Known Member
- Posts
- 1,819
- Location
- Leeds
no worries, i may know somebody in the know about brazing etc, il await pics, cheers
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
Winch piccies update sort of fing.....(NOT an excuse to bump this thread, oh no)
The motor looks reeally clean with no sign of overheating and bearings are free with no play
This is the bit that that needs replacing......Some hamfisted thug (Me) snapped the bolt which is the positive connection to the brushes and the plastic isolator that it goes through is partially melted. It's possible it may have just tightened up but would be better replaced.....and there int a lot of choice know anyway
Slight melting of insulation on the +ve cable but only right next to the connector which should be covered with a boot anyway (missing presumed dead)
The motor looks reeally clean with no sign of overheating and bearings are free with no play
This is the bit that that needs replacing......Some hamfisted thug (Me
) snapped the bolt which is the positive connection to the brushes and the plastic isolator that it goes through is partially melted. It's possible it may have just tightened up but would be better replaced.....and there int a lot of choice know anyway Slight melting of insulation on the +ve cable but only right next to the connector which should be covered with a boot anyway (missing presumed dead)
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
Still got these.....
Series deluxe dished bonnet, spare carrier has been removed.
Series 88 diesel stainless exhaust backbox and middle pipe
Series air filter box and bracket
Galv roofrack for an 88/90 with ladder
Rear folding forward facing seat, nearside
Offers?
Series deluxe dished bonnet, spare carrier has been removed.
Series 88 diesel stainless exhaust backbox and middle pipe
Series air filter box and bracket
Galv roofrack for an 88/90 with ladder
Rear folding forward facing seat, nearside
Offers?
blue beasty
Leaks an prone to bits dropping off
- Posts
- 63,106
- Location
- Gloucestercotshirewolds
Nobody want nuffink?
Gonna go to ebay soon cause I need some cash.....last chance
Gonna go to ebay soon cause I need some cash.....last chance
