rangie1998
Active Member
- Posts
- 279
- Location
- Leeds
Wanting to change blend motor as it's blowing cold only on passenger side. Looked on eBay, is there a specific one I need or are they all the same?
Changing blend motor
- Thread starter rangie1998
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 16,479
All the same I believe.
- Posts
- 58,170
- Location
- Preston Lancs.
If you buy a set obviously they are pre wired to the plug and colour coded. If you buy a single unit it will fit anywhere as long as you fit the pins in the correct places on the plug. ALL the motors are the same unit.
rangie1998
Active Member
- Posts
- 279
- Location
- Leeds
Thanks for the advice. Hopefully won't be too difficult to do!
stjohnsmythe
Active Member
- Posts
- 474
rangie1998
Active Member
- Posts
- 279
- Location
- Leeds
I will probably cut the wires and just solder to new motor, sounds easier than removing more dash than I need to.
gfromleeds
Well-Known Member
- Posts
- 2,234
- Location
- leeds. westyorkshire, uk
Sure ive seen on ebay some with 2 wires and some with more?
sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
They all have 5 wires
- Posts
- 58,170
- Location
- Preston Lancs.
The two wire ones are the motors that fit on the fans to open and close the inlets.
