Disco 1 carpets,

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
richieb

richieb

Active Member
Posts
216
Location
west sus sex
hi, my carpts are soaking wet in the front, i cant see a leak, do people remove the carpets and replace them with chequer plate or something? shame the carpet seems to go up under the centre console etc so i cant just take the floor bit out? need to do something before it turns it rotton
thanks
 
If you just plate it, there is a danger that the water will just fester under the plate, and rot things anyhow.

I have the same issue in the back of our D1. Alpine windows leak...
 
was thinking ofr a really good thick underseal layer in between and maybe clipping it in so it can be removed easy, but wonder what others have tone as road noise will be much worse etc
 
Leave the carpets in but get rid of the thick layer of sponge underlay/sound absorbing mat - it just holds water. The carpet is pretty good for not holding water especially if there is a small drain hole or two in the floor. Drill a couple, rustproof the whole floorpan and put the carpet back. It looks better than c-plate and keeps a bit of noise out. Don't forget to check it from time to time.
 
richieb said:
blimey that's a bit of a drastic amount of work, then what do you do with the bare transmission tunnel etc, i expect it looks rather crap!?
Click to expand...

Sure is I only read post #5, didn't see the ones before. I removed the carpet to weld up the floor and put it back afterwards.
Made a bit of an Arthur Hunt of this thread. I'm away to find my glasses now, no doubt I'll find them later on the top of my head:oops:
 
Yoyodyne said:
Leave the carpets in but get rid of the thick layer of sponge underlay/sound absorbing mat - it just holds water. The carpet is pretty good for not holding water especially if there is a small drain hole or two in the floor. Drill a couple, rustproof the whole floorpan and put the carpet back. It looks better than c-plate and keeps a bit of noise out. Don't forget to check it from time to time.
Click to expand...
will it pass an mot with holes drilled? I tried to pull the thick **** out but it wouldn't budge is it fixed to something?
 
I removed mine and fitted the proper discovery mats in to it.take up majority of the room the carpet covered and will reveal all the holes you have
 
Yep, when I bought my D1 Disco it had the drains from the A/C blocked and constantly soaking the floors, I removed all the underlay/sound deadening stuff in each footwell back to the intersection point with the tranny tunnel and just laid the carpet back onto the bare, (and thankfully not rusted into holes) metal floor, I think it allows a bit more road noise in but is acceptable for an old 4WD. Now if the carpet gets wet, like when I do deep water crossings, it is simple to just place something under the carpet to allow air to circulate and dry it in a reasonable time.
 
i got it out doday and dried it out in the wind, sound foam can stay out, found lots of patches welded in my floor! thought this was a solid one but not so sure now, the drivers floor has a few small holes so don't know if that's an mot fail or not but its draining the rain!! I have no idea where it's coming in from, very frustrating, I wish you could buy a liquid leak finder that you pour over the car and it finds leaks and fills it!! radweld for rain leaks!! maybe i'll melt some perolium jelly and pour it down the windscreen and it might set in the holes!!!
 
You must log in or register to reply here.

Similar threads

N
Multiple water leaks Discovery 2
2
Replies
28
Views
3K
Bone9
Bone9
Naf623
Disco 2 Footwell Leak Tracing
Replies
2
Views
739
Shedload
S
dag019
Fitting YRM extended second row floor upstand
Replies
14
Views
612
dag019
dag019
S
Lucas Starter Motor on Freelander 1
Replies
11
Views
636
Andy Warren
Andy Warren
S
Disco 1 Disco 1 Rust repair prep
2
Replies
20
Views
2K
sv_dOnut
S
Back
Top