Can't get the lower ball joint off!

guineafowl21 · Jun 22, 2015

Hi all,

02 Td4 S. I've bought a ball joint for the LF lower control arm. Various threads on here describe grinding off the rivets, so I've ground one down flush with the arm, but it won't press or hammer out. Do the rivets only come out one way? I'm attacking the bottom edge. I've tried drilling too, but they're hard as b*ggery. Do I just need to try harder or am I doing it wrong?

Cheers

C13tay1 · Jun 22, 2015

When I did mine..... Ground all the rivets down ..... Gave the ball joint a whack with the hammer and off it came

Nodge68 · Jun 22, 2015

The rivets are a very tight fit in the ball joint. I use a 3Lb club hammer and parallel punch, making sure that the arm is well supported. They will come out but require some persuasion.

Irishrover · Jun 22, 2015

The rivet heads are dimpled in the centre. Use a 4mm HSS drill first followed with an 8.5mm.
Don't run at high speed, it will burn the drill tip and if possible use a pillar drilling machine and ideally a cutting compound or at a push, ordinary engine oil to keep the drill cool.

Hippo · Jun 22, 2015

Make sure the new ball joint will fit first. Some of the arms are thicker than others.

teddywood1 · Jun 23, 2015

Always support the arm or when you hit it ,it will just bounce away and you can hit it fo r ever more and you will make no difference

jedi · Jun 23, 2015

teddywood1 · Jun 24, 2015

I think that would be just a tad over doing it that way

ER1C · Jun 24, 2015

teddywood1 said:
I think that would be just a tad over doing it that way

Yeahh I thought the military fatigues were too much as well.

guineafowl21 · Jun 25, 2015

Thanks everyone. I think I need a bigger hammer - just wanted to make sure I wasn't doing something stupid.

Can't get the lower ball joint off!

guineafowl21

Well-Known Member

C13tay1

Active Member

Nodge68

Well-Known Member

Irishrover

Well-Known Member

Hippo

Lord Hippo

teddywood1

Well-Known Member

jedi

Well-Known Member

teddywood1

Well-Known Member

ER1C

Well-Known Member

guineafowl21

Well-Known Member

Similar threads