paulyoung122
New Member
- Posts
- 3
anybody know the size of the torx bolt that holds the camshaft position sensor in place ? I wanna get the right tool for the job 
Paul
Paul
camshaft position sensor
- Thread starter paulyoung122
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
GasFiredDisco
New Member
- Posts
- 480
- Location
- In that cloud of smoke over there
Which engine do you have, it may help
AllanI
New Member
- Posts
- 189
- Location
- High Peak, Derbyshire
If it is a TD4 I think it's a TX20 but why not buy a small set of Torx bits which will be better value than buying a singleton.
Allan
Allan
paulyoung122
New Member
- Posts
- 3
Thx Allan, I will check that out (yep it's a TD4)
TD4_4x4
Active Member
- Posts
- 283
- Location
- North Yorkshire, UK
Any idea how I find out what to set the torque wrench to when doing the bolt back up? I looked in the Hayes manual can't find any information. Thanks!
Vehicle: '04 TD4 2.0
Vehicle: '04 TD4 2.0
TD4_4x4
Active Member
- Posts
- 283
- Location
- North Yorkshire, UK
Thank you fanatic.
Similar threads
