GreenHornet
Well-Known Member
- Posts
- 1,361
- Location
- Fleet, Hampshire
Matt that looks great. Can't wait to see it painted. May pop around tonight, but I'll be walking as my bearings still haven't arrived aarrrggghhhh
Building my rollcage
- Thread starter Matt Baxter
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Paulmitchell1984
Well-Known Member
- Posts
- 1,819
- Location
- Leeds
looking good mate...iv been thining recently though, how safe is it to have the cage going to sill/sliders rather than the chassis, have you strenghtened it in anyway?..how much tube did you use n the end then
Matt Baxter
Active Member
- Posts
- 551
- Location
- Fleet,welding up a disco
Slider are bolted through the sills and have added supports to the out riggers, but on th list of things to do are replace the sills with box section, but the sills are in very good condition and I made the sliders a while back and the slider tubes are also made from cds,
The amount of tube I will have used is around 32meters ��
The amount of tube I will have used is around 32meters ��
Matt Baxter
Active Member
- Posts
- 551
- Location
- Fleet,welding up a disco
Cage is now in etch primer so will paint it tomorrow after work and hopefully refit it Saturday morning
gummy bear
Active Member
- Posts
- 122
- Location
- Fleet,Hants
Looks a lot better in the flesh : ))
Matt Baxter
Active Member
- Posts
- 551
- Location
- Fleet,welding up a disco
Only just remembered to take some pics of the finished article
gummy bear
Active Member
- Posts
- 122
- Location
- Fleet,Hants
Sweet as : )
