Disco 1 Brakes: stopping power not always there

Mowog73 · Jun 8, 2018

I'm having an odd brake issue with my 1996 D1 Tdi, which has ABS.

Normally the brakes work find. If you push the pedal really hard, the ABS kicks-in and plusate the brakes. But sometimes, like this morning I pushed the pedal really hard and the brakes didn't lock up, nore did the ABS plusate the brakes. It almost felt like I wasn't going to stop in time. A few kilometres later, I turned in the drive at work and the brakes behaved normally. I am not getting an ABS warning light on the dash. Any ideas what the issue might be?

henrytilly · Jun 9, 2018

you could try bleeding them for a start easy job at little cost worth a go

Goc3k · Jun 9, 2018

If you have poor braking performance and get no lockup / abs pulsation when you need it most I'd check the vacuum pump first, then the booster - as long as you know the system has no leaks / isn't full of air (and that there is some meat left on the pads to boot!)

Mowog73 · Jun 10, 2018

The brakes pads, disks are all relatively new, all calipers are in good working order and the brake fluid was recently changed, so I know that portion of the braking systems is in good working order.

I hadn't thought of the vacuum pump. Is there a way of testing the vacuum pump?

Goc3k · Jun 10, 2018

The easiest test to check the system is, while parked and engine off -

Pump brakes up until rock hard, hold your foot firmly on the pedal to maintain pressure
Start the engine - pedal should drop about an inch further fairly quickly.

If the pedal needs two pumps once the engine is running to firm the brakes up, but everything else seems okay, I'd probs suspect the master cylinder next - especially if it is the original unit

Mowog73 · Jun 19, 2018

Thanks, I'll give this a try tonight.

Disco 1 Brakes: stopping power not always there

Mowog73

Member

henrytilly

Active Member

Goc3k

Well-Known Member

Mowog73

Member

Goc3k

Well-Known Member

Mowog73

Member

Similar threads