brake pressure switch

RangeRoller dt

Well-Sprung Member

Posts

14,393

Location

Trapped inside my head @ LZ asylum

• Sep 10, 2020

• #21

Tyke always start with simple stuff
check your fluid level, fuses related to ABS first
Engine compartment Fuse -
#24 5A
#27 30A
Maxi 3 - 40A
Couple of the relays are ABS related also can substitute from the other known ones to test

 

marjon

Well-Known Member

Full Member

Posts

16,727

Location

Bulgaria

• Sep 10, 2020

• #22

tyke100 said:

before i explode after spending today 170 unnecessary pound in this peace of metall for a new radiator it now has the red light for brakes on.
nanocom says brake pressure switch failure.

it is impossible spending this amount on money in any car. i wouldnt even spend at service costs in a new one and rather burn it.

joke aside

anyone has a partnumber for this brake pressure switch?
i not buying it from land rover. i would rather see them going bankrupt. and without this number i cant get anywhere by searching for one.

sorry. really peed of now.

Click to expand...

The problem is, you have done so much work on the car. The brake pressure switch could be related to the new accumulator thinghy, you were asking about bleeding brake (was it you not sure) what did you do if anything?

it’s very difficult sometimes to get all the pieces of the problem together,

the guys on here will not do you wrong so hang in there.

J

 

RangeRoller dt

Well-Sprung Member

Posts

14,393

Location

Trapped inside my head @ LZ asylum

• Sep 10, 2020

• #23

Too late for me I can’t keep up at the mo

 

tyke100

Active Member

Posts

418

Location

derby

• Sep 10, 2020

• #24

i may didnt bleed it properly. i hate doing it so i asked a friend to help me.
i try doing it myself tomorrow and also check the fuses. thanks so far. i update.

 

RangeRoller dt

Well-Sprung Member

Posts

14,393

Location

Trapped inside my head @ LZ asylum

• Sep 10, 2020

• #25

They do take a good bleeding most than regular vehicles

 

RangeRoller dt

Well-Sprung Member

Posts

14,393

Location

Trapped inside my head @ LZ asylum

• Sep 10, 2020

• #26

Level is checked at line after pump has built up pressure and stopped

 

tyke100

Active Member

Posts

418

Location

derby

• Sep 10, 2020

• #27

yes level is to the top. pump did take a while to work on the last two days. a bit longer as usual.
ill check all pipes and bleed again. hope this solves it.

 

tyke100

Active Member

Posts

418

Location

derby

• Sep 12, 2020

• #28

Done.
Brake pressure back.
All that messy work .
I hate relais. - dos that say what it was ?

Thanks guys.
Think i would give up a long time ago with all those little noggles on my own.