Disco 2 Brake disks guide screw

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
K

Kaijun

Active Member
Posts
237
Location
Berkshire, U. K.
Hi, I found one of D2 rear brake guide screws has been worn out, any good suggestions to remove it, if I have to drill out, do I need one for safety? Thanks!
 
If there is any bits of the cross head left, just use an impact driver. As far as I know they are just there to stop the brake disc falling off when you take the wheel and calliper off.
Just replace it with a new one, and don't do it up too tight!;)
It could fractionally affect the balance of the disc and therefore the wheel if you don't put it back.
Best of luck!:)
 
Stanleysteamer said:
If there is any bits of the cross head left, just use an impact driver. As far as I know they are just there to stop the brake disc falling off when you take the wheel and calliper off.
Just replace it with a new one, and don't do it up too tight!;)
It could fractionally affect the balance of the disc and therefore the wheel if you don't put it back.
Best of luck!:)
Click to expand...
 
Besides too much torque, most of those retaining screws are ruined because they are mistaken for Phillips. On the head, you will note 4 markings in addition to the main cross which means that it's a Pozidriv screw.
 
You must log in or register to reply here.

Similar threads

S
Freelander 2 (LR2) Brake Pedal Cruise Control Switch
Replies
0
Views
234
Stevelander 2
S
K
Disco 2 flare types
Replies
3
Views
676
PopPops
PopPops
K
Disco 2 replace brake jump flexi hoses
Replies
0
Views
499
Kaijun
K
K
Disco 2 Nanocomm does not bleed after 0.5L or more of brake fluid was lost in braking system
Replies
2
Views
572
Kaijun
K
D
Park brake warning light...
Replies
2
Views
523
Dan72
D
Back
Top