wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
Anyone know what size of Torx bit i need to remove front disc retaining screws on the Freelander 2?
|Brake disc screw Torx size?
- Thread starter wattfield
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Arctic2
Well-Known Member
- Posts
- 2,736
- Location
- Westmidlands
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
Cheers!
(And I don't think I've got one and I'm doing them tomorrow!)
GrumpyGel
Well-Known Member
- Posts
- 26,386
- Location
- Christchurch, New Zealand
Torx? What's that?
If a hammer doesn't work...
If a hammer doesn't work...
andyfreelandy
Well-Known Member
- Posts
- 5,560
- Location
- Devon
Standard fitment was, I believe, a posidrive screw. Upgrade is Torx.
GrumpyGel
Well-Known Member
- Posts
- 26,386
- Location
- Christchurch, New Zealand
Pretty sure my '99 F1 had 1 firips per solid disc rather than torx.
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
Got the right tool but still had to drill it out. Now the disc is seized solid. I’ve tried hammering, plus gas, and heating with a blow lamp, tried the nut & bolt through the carrier trick to push it out and broke one m8 bolt and bent the other. Any other ideas? I don’t want to get too destructive so I can’t get it to a garage if it doesn’t work!
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
did you use an impact driver
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
On the screw? Yes I did. That’s not the problem now though, the disc itself is seized on to the hub
- Posts
- 6,395
- Location
- North Perthshire
Did you drill the screw out fully....or has it flared over the edge of the recess?
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
Drilled off the head, actually think I might have drilled too muchDid you drill the screw out fully....or has it flared over the edge of the recess?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
usually does the job with a decent sized hammer and proper hit, whack the spigot part of disc with a large copper hammer
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
Been doing that for ages, drilling right through the screw now to make sure it’s not as @Beneagles suggsted then I’ll try the hammer again
- Posts
- 6,395
- Location
- North Perthshire
Any progress?
wattfield
AKA Dirk Diggler
- Posts
- 27,697
- Location
- Ayrshire-by-the-puddle
Nope. I've admitted defeat, it's going to the professionals!Any progress?
