Brake bias Vv on 90 300tdi.
- Thread starter mpd2378
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 11,023
- Location
- North of the Wall
Are you sure it's the brake bias valve that's leaking Mick? It should be mounted on the bulkhead, below and slightly to the right of the brake servo.
A leak from the bell housing could be the slave cylinder leaking.
tottot
Well-Known Member
- Posts
- 8,028
- Location
- west wales coast
Need more detail on this, a pic of the point the leak appears to be coming from mayby.
- Posts
- 11,023
- Location
- North of the Wall
Pretty sure those units are sealed, so I suspect one of the pipe unions must be leaking.
That is the brake bias valve Kev and it's fixed to the bulkhead. The bell housing is the round, flared out end of the gearbox that bolts on to the back of the engine block.
Hicap phill
Well-Known Member
- Posts
- 16,242
- Location
- Wiltshire
Sealed unit… replace
- Posts
- 11,023
- Location
- North of the Wall
Might just need a union nipped up Phill. Last time I looked they were very expensive. Hmmmm, that was about eight years ago though
If you do end up needing a replacement I have a brand new one sat on the shelf that I ordered for my rebuild (thread link) a few of months ago before discovering now I had the later brake master that did not need one!
Part number ANR1415 (link), it has also gone up in price since I ordered it in July I paid £116 for it from paddocks. I am based in Warwick if you are local or can post. if you end up needing one I am open to sensible offers as it is no use to me.
