Evoque Blind spot not working just a yellow spot in the left mirror it some time comes on and off.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

moonraker 3958

New Member
Posts
7
Location
East Yorkshire
Good afternoon it has been a long time science I have been logged on, I have had a freelander 1 and the I had a freelander 2 was very happy with them and now have now got a Range Rover Evoque Automatic 2 Litre Diesel five door very happy with it but the, Blind spot not working just a yellow spot in the left mirror it some time comes on and off and the waring triangle on the information centre .any one who can help please.
 
The yellow spot is a 'self test' and should be there when stationary, disappearing when above 3km/h. There are a few possible causes, defective mirrors, defective RADAR behind the sides of the rear bumper, defective / corroded / damaged wiring to the RADAR sensors, loose or damaged sensors / mountings. Unless you enjoy wasting time & money, you need to have some form of OBD diagnostics that can interrogate all vehicle systems, not just the 'big four'.
 
Good evening thank you for your input I have put a OBD on and it gave no codes the yellow spot is on all the time when driving it is only on the left mirror and not on the right mirror it is a annoyance .
Thank once more.
 
Then it could be the right mirror LED module is faulty - which would set a DTC, are you sure can you read all modules?
 
You should be looking for SODL & SODR on MS-CAN (co). It's not unusual for 'low voltage' DTC's to be stored, these only register during cranking and don't affect functionality.
These modules are VIN coded so will throw U2100 or U3002 codes if the module is improperly coded or swapped from another vehicle.
 
Good afternoon with refence to my last post about the Blind Spot Mirror I have had to take it to my local garage ,he has a very large OBD meter so I booked it in ,and this morning took it in and within twenty minuets he found a hundred and fifty nine codes he then took the car for a run it seems to be ok now all working very happy with it.
I thank Graulus for his in put and the the landy zone for all the help.
Moonraker.
 
Good afternoon re the Blind Spot Mirror issue on my Range Rover Evoque I have been away for ten days and during that time the car has been in the garage to have this problem sorted out on the first time it went in the garage for this problem I was told it was the ECU it had 159 fault codes on it
and they cleared them out and it worked for two days and it was back again so I took it back and told them to sort it out .
On my return went to the garage and big smile from the mechanic face and his first words was sorted it out.

So the big question was what was it he told me that there was two wirers in the loom was broken and to fix it was not hard but the work to take the bumper off was hard ,I have been driving it all week and it appears to be fine so I think it has now been fixed.so now can say it is SORTED I would like to thank all the members for all the replies and in puts on this problem.
Thank you all.
 
You must log in or register to reply here.

Similar threads

DollyBird
Engine disabled, keys not working, tried the guide “Re-synching the Range Rover P38 diesel engine with the Solved - BECM using a Nanocom” no luck
Replies
9
Views
1K
DollyBird
DollyBird
M
Both FOB not working, car would not start
Replies
3
Views
1K
maurizio82602
M
Blob
L322 Solved - C1A13-64 (AF) Pressure does not decrease when venting gallery
Replies
2
Views
3K
stuu
stuu
W
FL2 2009 Auto “Transmission Fault” and judder
Replies
2
Views
1K
Wpl23
W
A
ZFHP6 Not going above 3rd gear in Drive - ok in Sports mode
Replies
4
Views
2K
Bemble
B
Back
Top