Bent chassis

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P38 guy

P38 guy

Member
Posts
65
Location
Amman, Jordan
Hi how are you all doing I'm suspecting the chassis is bent from an old accident. And I got a few symptoms that as I think is from bent chassis which is the bumper and bull bar are facing downwards from the passenger side (Ihd) and normal from the driver side and the car looks like it's going sideways when driving.
IMG_6892.jpeg
IMG_6890.png
Anyone here got a p38 with bent chassis got the same symptoms or something like it? And did someone here have good luck fixing a bent p38 chassis? Because I don't feel like writing it off.
 
marjon said:
What are your symptoms & what was the accident?

J
Click to expand...
It was fixed poorly by an idiot, the front end wasn’t completely crushed, it was hit from the side then dad lost control and hit a wall in the right side
 

Attachments

  • IMG_6898.jpeg
    IMG_6898.jpeg
    334 KB · Views: 54
  • IMG_6899.jpeg
    IMG_6899.jpeg
    883.5 KB · Views: 54
P38 guy said:
I don’t remember but it didn’t work out
Click to expand...
That will be why the tyres wear then. Could be suspension/steering components which are bent rather than chassis. If the chassis is bent that badly I would have thought a bit of measuring would show where the damage is, or looking carefully might show up a damaged chassis rail.
 
Anaconda said:
That will be why the tyres wear then. Could be suspension/steering components which are bent rather than chassis. If the chassis is bent that badly I would have thought a bit of measuring would show where the damage is, or looking carefully might show up a damaged chassis rail.
Click to expand...
How could i measure? Also I replaced all the drivetrain after the accident
 
P38 guy said:
How could i measure? Also I replaced all the drivetrain after the accident
Click to expand...

Touch - Spanesi

touch
www.spanesi.com www.spanesi.com
Did you have a "proper" wheel alignment done with four wheel laser alignment?
Ideally take it to a professional workshop with the item I linked to for frame measurements.
If you replaced everything and the steering can't be aligned within spec then the chassis must be bent. Can you buy a new chassis?
 
You must log in or register to reply here.

Similar threads

dag019
Fitting YRM extended second row floor upstand
Replies
14
Views
881
dag019
dag019
S
richards chassis & pre-drilled holes for steps
Replies
1
Views
354
hughdavies
H
S
Rolling chassis trailer build. Head scratching
Replies
3
Views
459
boguing
boguing
JT_spark
P38 DSE Auto intermittent lack of power after vehicle has been hot
Replies
8
Views
694
brianp38dse
brianp38dse
T
P38A Dash Lifting Demist Vents
Replies
1
Views
516
pwood999
pwood999
Back
Top