Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
That's really butch, the standard item must be less than 1mm thick.
Battery Clamp - Measurements Required....
- Thread starter Saint.V8
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 16,479
lol...is a tad, but was all we had in less than 50mm flat bar, all the rest was 50mm and over which even though we had some 50x1.6mm, was too wide, but the 3mm flat does the job nicely!!
discool
Well-Known Member
- Posts
- 13,609
The UK MOT testers manual states "A battery insecure or leaking electrolyte" is a reason for rejection.
So if the battery moves etc
strange but the means or method of securing the battery is of no concern.
StuckAgainSteve
Well-Known Member
- Posts
- 2,276
- Location
- London
I was quite involved in the Mini scene in the late 80s, I personally know two Mini's burned out by loose tools in the back shorting the battery, (owners often chucked the cover) the battery falling through the rusty battery box wasn't uncommon either!
kevwill
Active Member
- Posts
- 930
- Location
- Sunny Hastings
So P38s fitted with coil springs that are more likely to roll over should have a battery strap then? Bit of straw clutching there Keith.
P38s fitted with coil springs should have the owner strapped up - indoors
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
P38s fitted with coil springs should have the owner strapped up - indoors
+1, that's not a battery clamp Saint, it's a lifting bracket!
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Back in the 60's I worked for NCR, the company mini van had the drivers seat propped up on bits of wood as the floor had rusted out, the battery was behind the drivers seat unsecured, one of the guys did an emergency stop, battery moved forward and a large steel stop bar dropped across the terminals, battery exploded covering the driver with acid. Fortunately he had a winter coat on and a hat so skin burns were limited to his neck. coat was ruined.
The car was so bad that if parked with one wheel on the kerb, none of the doors would open
kevwill
Active Member
- Posts
- 930
- Location
- Sunny Hastings
The car was so bad that if parked with one wheel on the kerb, none of the doors would open
Reminds me of a Triumph Spitfire I used to have!
StuckAgainSteve
Well-Known Member
- Posts
- 2,276
- Location
- London
Back in the 60's I worked for NCR, the company mini van had the drivers seat propped up on bits of wood as the floor had rusted out, the battery was behind the drivers seat unsecured, one of the guys did an emergency stop, battery moved forward and a large steel stop bar dropped across the terminals, battery exploded covering the driver with acid. Fortunately he had a winter coat on and a hat so skin burns were limited to his neck. coat was ruined.
The car was so bad that if parked with one wheel on the kerb, none of the doors would open
Quality BMC engineering!
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Reminds me of a Triumph Spitfire I used to have!
The E type I have been rebuilding for the last few years was the same. The sills had rotted and the doors wouldn't open. All that was recoverable was the front and rear bulkheads.
- Posts
- 58,170
- Location
- Preston Lancs.
