Ashcroft air locker drill and tap sizes?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

IamRobbie

Well-Known Member
Posts
2,800
Location
Derbyshire, j28 M1
Gonna buy an ashcroft air locker tomorrow from Paddocks to treat myself for my birthday today.

Looking on the website it says the drill bit from ashcroft is 29/64 which is around 11.5mm so I'll buy an 11.5mm drill bit and then the tap I've read is 1/4 bsp however that tap is smaller than 11mm isn't it?
 
Don't forget that the BSP size refers to the inside diameter of the pipe, so they're a lot bigger so as to allow for the wall thickness of those old iron gas and water pipes. So a 1/4" BSP would be around 1/2" in practice. So an 11 point something drill is probably about right.
 
Cheers guys. Ordered a thread and plug set of taps and brought the locker today with a tyre air set so I just need to find time to fit it all Into the rear, move the arb to the front and at some point I'd like to make a receiver for the compressor so it's got a tank that's a little bigger for airing up tyres. Might use a small fire extinguisher.
 
I'd avoid using an old, fire extinguisher due to needed a fill, return and drain on a tank.

These are cheap enough to pick up these days (£30+depending on size)

IMG_1629.jpg
 
Back
Top