Anyone got some old shocks?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
T

thetim

Well-Known Member
Posts
379
Am converting my suspension to allow me to run dual shocks on my back axle. I'll be running standard shocks with 2" lifted springs, so I need to reposition the mounts.

Has anyone got a set of standard shocks - two fronts and two rears - that they no longer need? Completely worn out Britparts would be fine; they don't need to be in working order as long as they extend and compress fully so I can use them to set up my geometry. The truck's a long way from being on the road and will get some good shockers before that point, but I'd like to make sure the mounts are all fitted in the right place!

Thanks in advance!
 
Im near Wolverhampton so not a million miles.

What model do you need them off?
I've got a full set of knackered genuine shocks off a defender 110, but I definitely cut one of the nut threads off. I'll dig em out tomorrow and post a pic, see if they're any use to you
 
They sound like what I'm after - for my own learning, are they the same as Disco / 90 shocks?
 
Couldn't tell you, I think disco 1 and rrc are the same. Ninety/one ten are different part numbers to 200/300tdi defenders and td5 are different numbers again. Dimensions wise im guessing all pre defenders and defenders would be extremely similar if not the same. Want me to put a tape measure along em fully extended and fully compressed?
 
Pic for clarity, notice stud cut off on one of the rears :oops: needs must :p

Should be able to dig a box out if you want em posted or I don't mind meeting you somewhere one of the days if you're in no rush
 

Attachments

  • 20190220_174212.jpg
    20190220_174212.jpg
    263.2 KB · Views: 119
Hi, sorry for the abrupt silence - was away for the weekend and then life took over. If you're able to post, that would be great - would Paypal be OK?

Flat, a dual shock setup is good for situations where a single shock would be overworked. Done properly, it avoids the shocks overheating and failing prematurely. My installation will be hampered by running with two standard shocks, so it will be overdamped. However, the hospital who will receive this truck do manage to overheat their shocks fairly regularly, at which point the shock oil goes thin and the damper becomes less effective. It's possible that we could swap overheated shocks onto this truck and, by using twice as many of them, still get effective damping.

The truck's been in build a long while - see attached taken mid-way through last year.
 

Attachments

  • Swimtruck (9).JPG
    Swimtruck (9).JPG
    171.5 KB · Views: 114
You must log in or register to reply here.

Similar threads

A
Rear shocks + springs
2
Replies
22
Views
1K
Chalky.
Chalky.
tottot
Armstrong dampers available?
Replies
6
Views
468
tottot
tottot
L
Parabolic leaf springs - shocks not fitting
Replies
7
Views
1K
300bhp/ton
300bhp/ton
currymunster
Disco 1 Front shocks
Replies
16
Views
1K
frostythor
frostythor
KISSMYAURA
Shocks To shave or not to shave?
2 3
Replies
40
Views
3K
RustyDefender
RustyDefender
Back
Top