spudy
Well-Known Member
- Posts
- 1,220
by detail's i mean all the dimension's
never had one, never really botherd about one but after being offered a **** rebel guard off a mate(not ferking cheep either) i have decided that i could bloody make it myself...
got some bits of 4mm 6mm and 8mm steel plate, and a good welder and i aint too bad at stitching either
..
if i had thought on i would have measured and done a diagram of his rebel guard while it was avalible but i dint so...
any of you nice peeps got a steering guard for a 200tdi disco sat about they can measure up and take some snaps of for me to have a look at?
i would need..
lenth plus width of the slide plate
depth from slide plate to edge of support frame
lenth and width of support frame's
distence to mounting point's plus any offset's there may be
this seem's very cheeky to me asking but as the saying goe's if you don't ask you will never get!!
cheers all
never had one, never really botherd about one but after being offered a **** rebel guard off a mate(not ferking cheep either) i have decided that i could bloody make it myself...
got some bits of 4mm 6mm and 8mm steel plate, and a good welder and i aint too bad at stitching either
..if i had thought on i would have measured and done a diagram of his rebel guard while it was avalible but i dint so...
any of you nice peeps got a steering guard for a 200tdi disco sat about they can measure up and take some snaps of for me to have a look at?
i would need..
lenth plus width of the slide plate
depth from slide plate to edge of support frame
lenth and width of support frame's
distence to mounting point's plus any offset's there may be
this seem's very cheeky to me asking but as the saying goe's if you don't ask you will never get!!
cheers all
