Any help appreciated. When selecting gear on auto box I have a vibration noise from rear...

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

Mungojerry

Member
Posts
41
Location
Fife Scotland
Hi all when selecting gear on auto box I have noticed a vibration noise similar to the tin sound of an exhaust vibrating...but rear box seem secure it does it with both reverse and drive and disappears when you as rev to pull away and no noise after starting to move....any help much appreciated thanks in advance
 
Mungojerry said:
Cheers will have a look and see ...but there didn't seem to be much movement in the rear box when I had a quick look.....
Thanks and will check them
Click to expand...

Give the rear box a good shake in all directions. It should have a good couple of inches movement all round before it hits another component, or it'll hit under engine movement.

It's also a good idea to check the lower engine tie bar, as those are known to go soft, allowing the engine to rock more than it should.
 
Nodge68 said:
Give the rear box a good shake in all directions. It should have a good couple of inches movement all round before it hits another component, or it'll hit under engine movement.

It's also a good idea to check the lower engine tie bar, as those are known to go soft, allowing the engine to rock more than it should.
Click to expand...
Just crawled under and the rear box has much more play in it from what I I can see it looks like the mount has gone....just driven for an hour to get home and the box is a lot looser than when I checked it initially....really appreciate the suggestion for direction to look
 
Mungojerry said:
Just crawled under and the rear box has much more play in it from what I I can see it looks like the mount has gone....just driven for an hour to get home and the box is a lot looser than when I checked it initially....really appreciate the suggestion for direction to look
Click to expand...

Are the mount rubbers orange? mine are.
 
Check the heat shield above the back box - it often comes loose on the F2 - needing bigger "penny washers" to hold it in place
 
Nodge68 said:
I've a feeling mine are the later OE type.

https://www.ebay.co.uk/i/3837455944...FfOLPobnjkJik-Xv_8pQARWupLS3bJRkaAgPiEALw_wcB

Black would be early originals.
Are any split?
Click to expand...
After getting underneath today and having a good look around it's a combination of a split rubber mount and the heat shield starting to get a bit of play in it...job for the weekend replace mount rubbers and reseat the bolts in the heat shield.
Many thanks for all the advise and the directions to look in....
Appreciated from all big thanks
 
You must log in or register to reply here.

Similar threads

T
Whats this noise? Help please
Replies
10
Views
648
Henry_b
Henry_b
A
Discovery 2. Question about auto box replacement, help most appreciated!
Replies
5
Views
1K
Stanleysteamer
Stanleysteamer
BroncoJr
D2 V8 Auto no drive when hot
Replies
5
Views
844
BroncoJr
BroncoJr
maydaysendhelp
2.0 td4 auto help pretty please
Replies
16
Views
2K
maydaysendhelp
maydaysendhelp
Tango91
  • Poll
Disco 2 Things I wish I knew when I took the body off (99 D2 TD5)
Replies
8
Views
3K
FlatbedPilot
FlatbedPilot
Back
Top