Alternator tensioner bracket position

I can’t work out where the bracket should go and/or whether I have the wrong fan belt.

I was thinking that the bracket went between the top bracket of the alternator and a bolt fixed to the bolt hole just to the left of that point. But as you can see in the photos, the gap is significantly less than the shortest length of the bracket.

If I move the alternator far enough that I can fit the bracket here, it is too far away for the fan belt to reach by a few centimetres.

As far as I can tell I have the right belt (1050, 10).

So, does the bracket attach to somewhere else (e.g. up one of the brackets on the water pump, or down to one of the bolts holding the timing marks)?

Best photo I've got to hand if that helps.

As per @woodO's post. on the bolt still in place on yours lower down.

WoodyO said:

https://1drv.ms/i/s!Av7EkJCZ55XHjVCmUbQE2iFGeaPr

Best photo I've got to hand if that helps.

Click to expand...

excellent. have done the same and it goes on fine. will test next time i get the engine going (sorting out the cooling system at the moment). thanks