kurtjohnson10
Well-Known Member
- Posts
- 15,235
- Location
- midlands
I will have a look tomorrow mate
P38A Air Suspension Valve
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
At least it'll be a decent one from Kurt. I'll hold fire until Kurt has had a dig around. I'm pretty sure my old valve block is in the shed somewhere though.
PPP38vouge
Active Member
- Posts
- 411
- Location
- deddington, oxfordshire
I have a spare valve block in the shed, i changed mine for a brand new one of Kurt, it worked perfectly fine when i swapped them over, i can sort a valve if you get stuck.
Paul.
Paul.
- Posts
- 3,878
- Location
- Near Heathrow.
Kurt is correct on the sizes. They should be 1.0, 2.0, 2.0, 2.5, 4.0 . . . . . or Diaphragm, Corner, Corner, Inlet, Exhaust.
But I have definitely seen some valve blocks with two 4.0 valve for the Inlet & Exhaust. My assumption is that using a 4.0 Inlet will allow the corners to raise faster ?
But I have definitely seen some valve blocks with two 4.0 valve for the Inlet & Exhaust. My assumption is that using a 4.0 Inlet will allow the corners to raise faster ?
kurtjohnson10
Well-Known Member
- Posts
- 15,235
- Location
- midlands
I have one mate , will get it posted to you by friday morning if thats ok?
if so pm me your address mate
kurtjohnson10
Well-Known Member
- Posts
- 15,235
- Location
- midlands
lol i have been called a few things on here mate
