andyfreelandy
Well-Known Member
- Posts
- 5,604
- Location
- Devon
On the air con pressure sensor plug, pin 1 and 3 give a 5V reference signal. Pin 3 is positive.
For the clutch to operate you need at least 1 volt between pins 1 and 2. Pin 2 is positive..
I don't know what pressure this represents.
Let me know where you measure your 1.25v.
You can emulate a working sensor and correct pressure by disconnecting pin 2 from sensor and placing a 470k ohm resistor between pin 3 and the pin2 lead to ecu.
This will eliminate a sensor or pressure fault.
For the clutch to operate you need at least 1 volt between pins 1 and 2. Pin 2 is positive..
I don't know what pressure this represents.
Let me know where you measure your 1.25v.
You can emulate a working sensor and correct pressure by disconnecting pin 2 from sensor and placing a 470k ohm resistor between pin 3 and the pin2 lead to ecu.
This will eliminate a sensor or pressure fault.