Advice needed Evoque P300e cracked hybrid battery casing

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
as Datatek look like a casting fault to me and a warranty issue. As most of the equipment used by JLR is European branded and the majority manufactured in China who are renowned for short cutting processes like there Indian owner
if it was due to damage the cracks would be sharp and have a crystallised structure not rounded and smooth from that of a LPS casting where the aluminium has failed to fill the mould correctly
 
Last edited:
backinblack said:
What's the betting that once challenged they say upon reflection it's perfectly safe sir, happy motoring, bye bye :)
Click to expand...
Seems you were right, extract from email received:
‘We have received communications from JLR that all checks have passed and we can release the vehicle back to yourself.’
I will speak to them further tomorrow when I collect the car.
 
DPH said:
Seems you were right, extract from email received:
‘We have received communications from JLR that all checks have passed and we can release the vehicle back to yourself.’
I will speak to them further tomorrow when I collect the car.
Click to expand...
I'm not surprised, it would cost a fortune to replace the casing and battery, better to say it's OK o save themselves a lot of cash. Personally I'd be inclined to get an expert opinion to protect yourself in the event of battery failure
 
Datatek said:
I would put money on that being a molding fault. There is no sign in the photo's of any impact damage that might have caused the split. The green stuff may have been applied at the factory.
You may need to employ an expert to produce a report.
Click to expand...
And there is a void in the top "corner" that looks like it was introduced during casting. That greeny goo was probably factory, or workshop applied.

Stick with their first story, and tell them it needed replacing!

If you'd shelled out nearly 11K, would they have backtracked and returned your money if they found it was fine inside and clearly caused by poor casting??? Like hell they would have!

Sheer incompetence!
 
That is a classic casting failure. It is called "Cold Shut" and it happens during the casting process: - Cold shut defects are cracks that have round edges. They occur when metal flows into the mold from more than one point. However, the metal is too cold and cannot merge properly to form a perfect piece.
 
Datatek said:
I'm not surprised, it would cost a fortune to replace the casing and battery, better to say it's OK o save themselves a lot of cash. Personally I'd be inclined to get an expert opinion to protect yourself in the event of battery failure
Click to expand...
Especially as these batteries have a reputation for spontaneously combusting, especially if damaged :rolleyes:

Note: I post this reply purely out of concern for the OP's safety, it is not my intention to start a discussion on the subject.
 
norseman said:
Especially as these batteries have a reputation for spontaneously combusting, especially if damaged :rolleyes:

Note: I post this reply purely out of concern for the OP's safety, it is not my intention to start a discussion on the subject.
Click to expand...
Allegedly, t was an Ejoke hybrid that started the fire that burnt down the multistory car park at Luton airport.
 
You must log in or register to reply here.

Similar threads

D
Disco sport p300e hybrid battery issue
Replies
1
Views
713
Scottydog1
S
R
Hybrid battery failure
2
Replies
28
Views
8K
roythebus
R
Blob
L322 Fixed! - P0046 - Where is the boost control solenoid?
Replies
17
Views
3K
Grrrrrr
Grrrrrr
feyniriel
P38 EAS problems
Replies
18
Views
1K
pwood999
pwood999
Blob
L322 (Not your usual) battery drain
Replies
7
Views
2K
Datatek
Datatek
Back
Top