Pat Bryant
Member
- Posts
- 45
- Location
- Stafford
Afternoon All,
Removed the PUMP to VALVE BLOCK (corroded) pipe on my 1999 TD5 ACE system after it leaked away nearly all the fluid; fortunate that I was on short trip. I think it may have been previously replaced as it is split by a union inside the wheel arch. Bit of a fiddle but I thought I had won this one until John Craddock (my local) parts told me it was obsolete and an internet search etc.does not help either. Anyone know where to find one? I called a hydraulic specialist but as soon as I said 'land Rover' they replied with "Ooh special fittings/threads/sizes etc." Not sure I believe that but then it was made in Solihull. I have read that a piece of 10mm soft copper pipe with brass compression fitting is an option but I worry that the system pressure is too high and if I try this method there is no going back as I will need to cut off the flared end.
Grateful for any help here. Best,
Pat
Removed the PUMP to VALVE BLOCK (corroded) pipe on my 1999 TD5 ACE system after it leaked away nearly all the fluid; fortunate that I was on short trip. I think it may have been previously replaced as it is split by a union inside the wheel arch. Bit of a fiddle but I thought I had won this one until John Craddock (my local) parts told me it was obsolete and an internet search etc.does not help either. Anyone know where to find one? I called a hydraulic specialist but as soon as I said 'land Rover' they replied with "Ooh special fittings/threads/sizes etc." Not sure I believe that but then it was made in Solihull. I have read that a piece of 10mm soft copper pipe with brass compression fitting is an option but I worry that the system pressure is too high and if I try this method there is no going back as I will need to cut off the flared end.
Grateful for any help here. Best,
Pat