abs/traction control

Hi all,
Just started up my P38 and two warning came on 1st for abs, then after a few second traction control. Anybody have any ideas?

Jon

my mate just had a similar problem on his late classic.as far as i am aware the abs and traction control both work on the same sensors. it turned out his problem was air gaps between the sensor and wheel hub had opened up. these required a gentle tap to re seat them and a faulty brake light switch. he had the faults tested the local independant and the computer showed the faults straight away. reset the ecu been ok since. or you could take it for a run and see if it clears itself. but take your time. i hope this gives you some ideas.

switch the engine off and on again - always works for me.