Doolinjames
Active Member
- Posts
- 137
- Location
- denny
Where is the abs ECU.?under seat or behind glovebox
P38A ABS & TC fault. - FIXED!
- Thread starter DanClarke
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
Behind glovebox
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
What about the abs pump noise
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
Nanacom no comunication with the abs ECU.sounds like ECU
- Posts
- 19,317
- Location
- Buckinghamshire, UK. ('95 DT)
From memory I think it is ignition on but no movement to connectbto ABS computer. Check for green verdigris on the OBD socket.
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
Is that grap on the obd socket
Datatek
Well-Known Member
- Posts
- 45,063
- Location
- Near Poitiers SW France
Yes and in the ABS ECU connector.
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
Ok I will have a look
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
I finally got nanacom to talk to the abs ECU it's now telling me the left abs sensor gap is too wide
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
I buggered about with the relays then nanacom was ok after that
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
And looks like a pig to get out a well
- Posts
- 19,317
- Location
- Buckinghamshire, UK. ('95 DT)
No, should be able to access the bokts without moving glove-box.
- Posts
- 12,669
- Location
- Sud ouest France !
If the sensor moves, tap it in until it just touches the abs ring and the ring will set the gap itself
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
I think it's seized.replacment I think
Datatek
Well-Known Member
- Posts
- 45,063
- Location
- Near Poitiers SW France
Try some Plus Gas round it left over night, might just free it off if you are lucky.
Doolinjames
Active Member
- Posts
- 137
- Location
- denny
Ok I will try that
