A frame balljoint nut removal

69disco · Jul 27, 2013

Read the threads on here regarding A frame balljoint removal and I can only conclude I'm doing something wrong!
I cannot get a spanner or socket onto the balljoint nut. Socket just doesn't fit in at all. 30mm ring and open spanners don't fit either- fuel tank is in the way. Tried every possible angle, every spanner, every adjustable I've got, nothing fits.
Obviously it can be undone- so how do you get a spanner on the thing?

jamesmartin · Jul 27, 2013

i use a std short socket with 6 inch extension but have ground sockets shorter before , at worst you can split it with a decent cold chisel inline with one of slots

69disco · Jul 27, 2013

Yeah, tried to look for shallow sockets but can't seem to find anything on 30mm that fits. Not keen on grinding down a socket either unless I have to. Looked a a grinder on the nut but doesn't fit.
Never had lot of success using cold chisel to split nut before but will try if I can't find a socket to fit. Is there a factory tool?

jamesmartin · Jul 27, 2013

69disco said:
Yeah, tried to look for shallow sockets but can't seem to find anything on 30mm that fits. Not keen on grinding down a socket either unless I have to. Looked a a grinder on the nut but doesn't fit.
Never had lot of success using cold chisel to split nut before but will try if I can't find a socket to fit. Is there a factory tool?

not hard to do ,split across center of a flat

MPfive · Jul 28, 2013

Silly question,but have you taken the split pin out? Mine was crudded up so much I couldn't get it out,so I had to hammer the socket on and use a breaker bar to snap it out.I think I used an imperial socket to get it out.The new one went on with an normal 30mm spanner and I've got a tank guard in the way.

Pikey · Jul 28, 2013

I split the one on the old disco, with a cold chisel. make sure it's sharp.

Silverbeard50 · Jul 28, 2013

I used a 30mm impact socket bought from Halfords. A good few mm shorter than a standard socket and waisted towards the square drive end; made all the difference to getting it into the available space.

69disco · Jul 28, 2013

Yeah, split pin is out. The only part of it that wasn't rusted!

Silverbeard50 said:
I used a 30mm impact socket bought from Halfords. A good few mm shorter than a standard socket and waisted towards the square drive end; made all the difference to getting it into the available space.

Excellent, thanks! Will get one tomorrow and have a go. Prefer to use socket if possible, then I can use the breaker bar on it

A frame balljoint nut removal

69disco

New Member

jamesmartin

Well-Known Member

69disco

New Member

jamesmartin

Well-Known Member

MPfive

Active Member

Pikey

Dummy Ejection Facilitator..

Silverbeard50

Member

69disco

New Member

Similar threads