Hi. In looking for a replacement brake master cylinder for my 1989 90, Ebay comes up with many that are listed as 110, but say will fit a 90. Ones listed for the 90 also appear more expensive than for the 110. They both look the same as what is fitted now, so what is the difference? I'm guessing the 110 produces more pressure for a longer pipe run?
90 brake master cylinder replacement
- Thread starter DMB24
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Gmacz
Well-Known Member
- Posts
- 968
- Location
- Forfar/Dundee
Goto paddocks land rover parts and get it there. Same items that will be on Ebay but easier to get right one. Vin number helps as well.
- Posts
- 9,098
- Location
- North Lincs
As above and buy quality. The cheap ones are cheap for a reason 
ask me how I know....
ask me how I know.... Would Britpart and Bearmach be considered cheap? I've always been happy with these brands in the past.As above and buy quality. The cheap ones are cheap for a reason
- Posts
- 9,098
- Location
- North Lincs
If you are happy with Britpart no worries. I used them and have had to replace the clutch slave just a few months later. The water pump lasted 15 miles!! You speak as you find, my Britpart shocks, brakes and stub axles are all fine
Gmacz
Well-Known Member
- Posts
- 968
- Location
- Forfar/Dundee
You could just get a seal kit for your original. I did this, easy fit and £6 for a complete refurb on mine. Over 2 years no problems. You would have to check what seal kit fits yours.
Similar threads
