3D printed aimable heater vents - anyone got a source?

Hertz32 · Jun 30, 2021

I saw a chap on eBay selling rotatable heater vents for the pre-puma dash a while back, but the listing was taken down a while back and never reappeared!
Anyone know of where I can pick a pair up, or have access to a 3D printer and some CAD software to do a knock off set?

lightning · Jun 30, 2021

lt's a good idea. Where on the dash would you fit them, in the centre console?

bluedog333 · Jun 30, 2021

lightning said:
lt's a good idea. Where on the dash would you fit them, in the centre console?

They look like they’re direct replacements for the vents under the dash .

lightning · Jun 30, 2021

Not sure there would be much to be gained by fitting adjustable nozzles to those, they seem to warm my feet just fine in Winter, l wouldn't want the warm air to go anywhere else.

bluedog333 · Jun 30, 2021

One of the most effective and cheapest mods I have done on my Landy was turn the lower vents upside down and swap the passenger side for the driver’s and vice versa. Still get some air pumped down to the feet, but the bias is now aimed upwards and towards the occupants’ bodies and faces. So much more useful!

resto_d1 · Jun 30, 2021

Believe these are on either the mud stuff or defender upgrades site. I just did same as rhe chap above and spun them around!

resto_d1 · Jun 30, 2021

https://defenderupgrades.co.uk/product/land-rover-defender-td5-movable-lower-vents/

Knew I’d see them. 70 quid for a bit of plastic!!!!

3D printed aimable heater vents - anyone got a source?

Hertz32

Member

lightning

Well-Known Member

bluedog333

Well-Known Member

lightning

Well-Known Member

bluedog333

Well-Known Member

resto_d1

Well-Known Member

resto_d1

Well-Known Member

Similar threads