300tdi pulley bolt
- Thread starter shadow644
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Jaswilliams
Active Member
- Posts
- 260
- Location
- zummerzet
Put it in fourth and get a friend to stand on the brakes ?
Mark L
Well-Known Member
- Posts
- 2,693
- Location
- Tamworth - Staffs
We used an air gun on mine, as it's a pain in the arse with an auto.
Thor1950
Well-Known Member
- Posts
- 39,238
- Location
- Land of the midnight sun
the only way I found to do it with the auto is to remove the blanking plate on the back of the drive plate and put a locking pin in,I believe a drill bit of the correct size will do the trick too,just can't remember what size,I torqued mine up to 300nm as thats as far as the wrench would go. If you get stuck give me a shout and I'll try and explain better.
lyron
Active Member
- Posts
- 536
- Location
- ibstock liecestershire
whip out the starter motor. wedge a large screwdriver or crowbar in the flywheel. but do make sure it's wedged in tight, because if it slips it could damage the ring gear,
ron.
ron.
