RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
300tdi inlet manifold full of dried oil
- Thread starter RustyDefender
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D1Nut
Well-Known Member
- Posts
- 396
- Location
- South Africa
If the intercooler and intake hasn't been cleaned in a couple of years that isn't bad
I would clean all the pipes and fittings from the turbo to the inlet manifold as well as wipe out the intake pipe - last couple of inches after the pipe connecting from the oil separator
then maybe monitor the last pipe going into the inlet manifold as well as the short elbow that comes out of the turbo in a month or 2
I nearly want to say that crud is normal if not cleaned for a long time
Actually the fact that you say it's dry tells me that the turbo isnt gone as the oil has had time to dry
I would clean all the pipes and fittings from the turbo to the inlet manifold as well as wipe out the intake pipe - last couple of inches after the pipe connecting from the oil separator
then maybe monitor the last pipe going into the inlet manifold as well as the short elbow that comes out of the turbo in a month or 2
I nearly want to say that crud is normal if not cleaned for a long time
Actually the fact that you say it's dry tells me that the turbo isnt gone as the oil has had time to dry
RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
Got a new intercooler + pipes fitted last night.. but got to clean this thing out just wanted to make sure i wasn't putting it back on for it to be full of oil in a few weeks time
RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
nah it's blanked off (was cleaned after it was blanked)
Valve clearances last checked? lash caps stil present?
RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
all caps still there.. valve clearances.. well they look fine when looking inwards
I meant the valve clearance that you adjust on the rockers.
RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
yeah i know what you meant.. but i aint taking the rocker cover off just for a bit of oil in the inlet manifold lol
Only four bolts and a guaranteed oil leaks afterwards
RustyDefender
Well-Known Member
- Posts
- 567
- Location
- Lake District
not it i weld it back on!Only four bolts and a guaranteed oil leaks afterwards
