300 tdi clutch change

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
200tdi ayre said:
If the arm pushed through I doubt there would be much pressure
Click to expand...
thered be lots of pressure.
enough not to press the peddle. the push rod hits the back of bell housing, and if you push the clutch hard enough, it pushes the rod thru the ally housing!
my guess would be the release bearing's collapsed, and slid inside the fork.
be a matter of time before it slides far enough for the push rod to bottom out.
 
thanks again for the replies all :)

seriously thinking about starting this tomorrow now, lol, so will be many more questions asked no doubt, just one more question for now, how do i upload a profile pic to side of me name? lol :)

thanks all :)
 
nrgserv said:
thered be lots of pressure.
enough not to press the peddle. the push rod hits the back of bell housing, and if you push the clutch hard enough, it pushes the rod thru the ally housing!
my guess would be the release bearing's collapsed, and slid inside the fork.
be a matter of time before it slides far enough for the push rod to bottom out.
Click to expand...

Sorry yes that's what I was thinking just explained it wrong
 
You must log in or register to reply here.

Similar threads

O
Clutch pushing rod + plastic clip
Replies
4
Views
611
Steven Sheppard
S
A
Discovery 1 300 tdi new clutch will not get no gears
Replies
9
Views
1K
liliana fox
L
Wagon Loon
300 tdi I gas flowed my new cylinder head, after head gasket fail, 97 Defender pick-up Peggy
2
Replies
33
Views
2K
Stanleysteamer
Stanleysteamer
J
300 Tdi engine swap story - and a few questions
Replies
13
Views
2K
doriz
doriz
J
300 Tdi Engine back in, nearly - Story and at the end Questions
Replies
0
Views
590
jer_300Tdi_90
J
Back
Top