miles6645
New Member
- Posts
- 16
- Location
- southampton, hampshire
Yes I meant rocker. Doh ! Will reset all tappets and valve clearances.
300 head changed after blown head now wont start. help!
- Thread starter miles6645
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
miles6645
New Member
- Posts
- 16
- Location
- southampton, hampshire
Ok then. Tonight I rechecked all the valve clearances and a few needed slackening off a little. I thought that the old girl would then fire up. Not to be. She turned over sounded like she was going to start but there was a fair bit of steam coming from near the exhaust manifold. Is this normal? When she just wouldn't go I looked at the area I could see the steam coming from and could hear what sounded like water dripping from within the head. Could it be that the head gasket is knackered again? And letting water into the pots ?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
much water in the cylinders it would lock on the starter ,was it new head?
miles6645
New Member
- Posts
- 16
- Location
- southampton, hampshire
Yes it was a new head fitted with old valves etc.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
did you lap valves in
Pikey
Dummy Ejection Facilitator..
- Posts
- 47,185
- Location
- in Baron Wet Bum's Slave pit..
Did you check the face of the block for wear/warped?? Sounds like you've done the head but not checked the block.
miles6645
New Member
- Posts
- 16
- Location
- southampton, hampshire
Yes I lapped the valves in and checked them for correct seating. I did check the block quickly with a metal ruler and she seemed ok.
miles6645
New Member
- Posts
- 16
- Location
- southampton, hampshire
Well took head off again today, due to water loss, and the head gasket I got off eBay was leaking like a sieve. So rechecked head and block for flatness and all ok.
Took a trip to west 4x4 got a new gasket bolted her back together and everything is spot on.
Fired up straight away.
So moral of the story is don't buy crap gaskets off eBay.
Thanks to everyone for all the help and suggestions.
Hopefully one day I will be able to help all of you with something.
Took a trip to west 4x4 got a new gasket bolted her back together and everything is spot on.
Fired up straight away.
So moral of the story is don't buy crap gaskets off eBay.
Thanks to everyone for all the help and suggestions.
Hopefully one day I will be able to help all of you with something.
Similar threads
