300 head changed after blown head now wont start. help!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
miles6645

miles6645

New Member
Posts
16
Location
southampton, hampshire
Hi all, i am new to this forum and am hoping that somene can help.

Well to start my 300 tdi disco blew its head gasket :eek:(due to p gasket failure) so replaced p gasket and head gasket,bolts etc.

Had head pressure tested and it was fubar'd.:mad: So new head purchased and all valves and springs etc removed from old head and reseated in new one.
The valves are all good and straight as are push rods.

head bolted back down using haynes manual for torque settings ? once all bolted down and back together turned over by hand on crank bolt and adjusted valve clearances. everything done i tried starting on key and she just turns over but doesn't want to fire up.

I have fuel at the rail and system primed double checked.
Doesn't seem to be any water leaking anywhere as have checked at expansion bottle and on thermostat bung.

please help as i am at a complete loss on what to do next.:confused:

thanks
 
timing or piston rings stuck-when your sure timing is right then consider dose of easy start or petroleum based brake cleaner
 
8 thou and rule of 9 is correct ,if you remove injector pipes fuel should pulse out ,lift pumps often fail but isnt noticed till system is disturbed
 
Hi, I had a very similar issue.

My fault was tappets. However, I checked everything before I found that. Have you bled your fuel filter? James Martin was brilliant help with mine :)
 
are you sure timing is correct even 1or2 cogs out will cause no compression as valves could be open also ( fuel could be out so going to 1 instead of 2 )example !!!
i would double check this first
check you have done timing right way around aswell ie cylinder is on compression stroke !!
good luck
 
but better to check everything as we are really trying to cure the problem blind so dont really know the history of whats being done and yes your right mate
 
miles6645 said:
Ok thanks all will take the head off later today and check the tappets and everything along those lines. Will let you all know how things go.
Click to expand...
rocker cover i hope you mean ,when setting tappets just turn engine clockwise only as looking from front and set the appropiate tappet when other has just reached fully open
 
You must log in or register to reply here.

Similar threads

Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
559
Padda.116
Padda.116
C
300tdi head gasket failure issues
Replies
2
Views
1K
Chris6640
C
Wagon Loon
300 tdi I gas flowed my new cylinder head, after head gasket fail, 97 Defender pick-up Peggy
2
Replies
33
Views
4K
Stanleysteamer
Stanleysteamer
A
P38A Head Gasket Kit & ARP Bolts ?
Replies
17
Views
390
kermit_rr
kermit_rr
K
Landrover defender 300 tdi engine noise after having gasket done ???
Replies
5
Views
418
lynall
L
Back
Top