3.5 carb v8 HELP

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
If you have points in the dizzy then you will have a condenser in there too

This is one with the points
http://www.ebay.co.uk/itm/Rover-V8-Distributor-Points-and-condenser-to-fit-Lucas-35D-distributor-/360651815543?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item53f885fa77

If you have a good spark then chances are condenser is good. worth changing anyway ,next thing is the spark at the right time?
Could be retarded ignition or maybe vac pipe off, advance plate not advancing.

Have you tried carb cleaner sprayed into inlet when cranking, if no go then spark not at correct time, if it fires then fuel not getting into engine:)

Is the ignition on when cranking? possible to get wires on wrong and shut power off while cranking, just a thought
 
Tried easy start direct to air inlet on carb nothing and the fuel is coming out fast and well Im not sure on the condenser I will have a look. Damn v8 should have done the 200 tdi conversion lol
 
if it wont rev oucl be timing well out but would be odd if it was working ok before. how were the dashpots? might be a carb rebuild needed, floats could be sticking or nethin
 
ok so after 2 hours tinkering here is what i know fuel is good to the carbs no start put a bit of fuel in the carb starts lovely maybe blocked jets bit more history of the car before i got it the old owner hadnt started it for 18 months
 
ozzz said:
ok so after 2 hours tinkering here is what i know fuel is good to the carbs no start put a bit of fuel in the carb starts lovely maybe blocked jets bit more history of the car before i got it the old owner hadnt started it for 18 months
Click to expand...

Should have started on carb cleaner if starts on petrol

needle valves in float chambers could be stuck and not letting petrol pump through, floats could be sticking if petrol had dried out and it was stood a while they will be corroded.

I would take bottoms off carbs and clean and set floats, make sure it all works, you can clean jets while you are in there.

And are you drawing old petrol from the tank, it goes off ??
 
Last edited:
Its fresh fuel in the tank and pretty much a whole tank lol I thought about stuck needles myself as it seems strange that its affecting both carbs thanx again for your help
 
ozzz said:
Are the needles on springs?
Click to expand...

Yes little sprung loaded valves in float chambers, mine used to stick open after a while on gas because no petrol in chambers, yours had petrol in so may be stuck shut
 
two checks

fuel delivery to carbs drop the fuel connection from the carb from the tank crank it and see if theres a delivery .help needed and caution petrol is :flame: dont burn the bast**d if fuel delivers then check the bowls and the filters , if it doesn't then check the pump .

reconnect all hoses . proceed to check 2


check number 2

have you got a propane blowtorch .
Dont light it
direct propane into the carb opening and crank it If it trys to fire then its fuel related . propane blow torch = raw gas conversion
 
autogas said:
two checks

fuel delivery to carbs drop the fuel connection from the carb from the tank crank it and see if theres a delivery .help needed and caution petrol is :flame: dont burn the bast**d if fuel delivers then check the bowls and the filters , if it doesn't then check the pump .

reconnect all hoses . proceed to check 2


check number 2

have you got a propane blowtorch .
Dont light it
direct propane into the carb opening and crank it If it trys to fire then its fuel related . propane blow torch = raw gas conversion
Click to expand...


Never thought of that, good idea that man....:D

 
Ok fuel is good carbs are bad I disconnected the fuel line ran it to the carb inlet started and ran like a dream till I pressed the loud peddle
 
yeah yeah lol.

gonna have an operation on my arm this week so will be fecked for 6 at least but if you are still stuck afta I will come over and take the **** for ya :p
 
You must log in or register to reply here.

Similar threads

L
WHICH CARB FEEDS WHICH CYLINFER ON A 3,5 v8 WITH SU's
Replies
2
Views
994
lrjohn
L
L
CHOKE CONTROL ON V8- WHERE SHOULD IT BE?
Replies
2
Views
279
Hicap phill
H
W
FL2 2009 Engine starts then slowly stops unless
Replies
4
Views
489
Hippo
Hippo
L
Discovery 1 3.5 Fuel Pump and Starting Procedure
Replies
2
Views
579
lrjohn
L
cappers
3.5 hotwire efi won't start - solved, poor connection to coil -ve!
Replies
14
Views
2K
AllanWorms
AllanWorms
Back
Top