Lowlight
Active Member
- Posts
- 487
- Location
- North Wales
Just fitted a boost gauge and thought I'd take a few pics as I found a nice route through to the engine bay that doesn't appear on any of the threads I found.
Just take off the wiper motor cover and put it through the washer hose hole:
That brings the hose out by the heater box:
A quick cut into the hose from the wastegate later it was connected (although I'll be tapping it into the inlet manifold next time it's off):
The gauge is easy enough to fit and job's a good un:
Took about 20 mins and the hose routing worked really well, remember to put something round the pipe where it goes through the bulk head to avoid rubbing through it though.
Just take off the wiper motor cover and put it through the washer hose hole:
That brings the hose out by the heater box:
A quick cut into the hose from the wastegate later it was connected (although I'll be tapping it into the inlet manifold next time it's off):
The gauge is easy enough to fit and job's a good un:
Took about 20 mins and the hose routing worked really well, remember to put something round the pipe where it goes through the bulk head to avoid rubbing through it though.
