200tdi temp reading

RICK · Feb 25, 2006

hello everybody , i'm new to all this forum stuff so be gentle . i need some advise from somebody , i'v just converted my na 90 to 200tdi and have noticed something not quite right , the engine runs fine , there is no smoke or anything else wrong but the temp gauge is reading high and i don't understand . i've flushed the rad and the engine , the water is not boiling and iv'e bled it . it is not using any water and iv'e changed the thermostat . iv'e spoken to a friend of mine and he said his doe's the same thing , has anybody heard of this before . i was wondering if the temp sender and the gauge are incompatable . any info would be greatly welcome .

ormus · Feb 25, 2006

dont know for sure but suspect that the 2 are incompatable. your temps may be fine. is it possible to check with a proper temp probe?

i doubt it, but maybe the old rad is not big enough for the job?

yella · Feb 25, 2006

it could be that the calibration on the temp gauge is set different to the temp sender on the engine. see if the sender off the n/a engin will fit the tdi.

RICK · Feb 25, 2006

thanks everybody for the help , i'll try the old sender and see what happens , for some reason i had'nt thought of that . by the way i'm using the disco rad not the na one

RICK · Feb 26, 2006

good morning everybody, jusy to let you know i changed the sender for the na one and it's all good , oil changed , filters changed goe's like a gazelle , well not quite but you know what i mean . thank's for the help.

yella · Feb 26, 2006

nice one mate

RICK · Feb 26, 2006

hello again yella , you following me

so yella what do you think of the series three question , can it be done without to much mods .

200tdi temp reading

RICK

New Member

ormus

New Member

yella

New Member

RICK

New Member

RICK

New Member

yella

New Member

RICK

New Member

Similar threads