Skolmate
Active Member
- Posts
- 168
- Location
- Manchester
Thanks
200tdi ignition switch melted cables
- Thread starter Skolmate
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Thanks
Skolmate
Active Member
- Posts
- 168
- Location
- Manchester
Flossie
Well-Known Member
- Posts
- 11,001
- Location
- Shropshire
Have you got a relay for the heater plugs? My NAD didn't so the full load was carried by the switch contacts.
I had similar melted wires on mine, spotted during the rebuild 14 yrs ago so I used those wires to trigger a relay instead, mounted it behind the fuse panel.
You may need a new ign switch too but they are quite cheap.
I had similar melted wires on mine, spotted during the rebuild 14 yrs ago so I used those wires to trigger a relay instead, mounted it behind the fuse panel.
You may need a new ign switch too but they are quite cheap.
- Posts
- 14,902
- Location
- Doncaster
Clean all earth and wiring connections and replace any discoloured wiring as best you can.
Life's a beeatch sometimes. Mine set alight (actually I set it alight almost accidentally) and burned wiring out, but in the end it helped 'cos so much of the rest of the wiring is pretty duff, so we have an on-going plan of attack to change bits of wiring as and when we have access.
Life's a beeatch sometimes. Mine set alight (actually I set it alight almost accidentally) and burned wiring out, but in the end it helped 'cos so much of the rest of the wiring is pretty duff, so we have an on-going plan of attack to change bits of wiring as and when we have access.
