2" lift freelander

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
A

andrew bagnall

Member
Posts
14
Location
sheffield
hi guys please don't hammer me for doing it i know its not most peoples taste but i am lifting my freelander 2" i have ordered the lift blocks that go inbetween suspension top mounts. the only thing i need advice on with fitting is camber. i have ordered some camber adj bolts wich go in the bottom clamp of the strut but how do i set the camber do i need a camber guage and do adjustments have to be made with the vheicle's weight fully on the ground or jacked up. also do the rear have to be done too ? all advice will be much apreciated
cheers in advance guys
 
You fit the kit. Trim arches. Move pipes. Fit camber bolts. Drive around block to settle suspension. Grovel under it and adjust camber to get the wheel vertical at leaning in a smidge. Then get 4 wheel alignment done.
 
That's how I do it. Nice flat ground. The wheel alignment check will tell you if it's in spec. Last one I did was pretty much spot on by eye. It's easier to see than toe angle
 
You can. They don't get thrown out as much. The front makes a big difference to the handling especially in the wet. I've done mine. Most don't though.
 
You must log in or register to reply here.

Similar threads

xDParis64
VCU test result + Lift Kit
Replies
8
Views
1K
xDParis64
xDParis64
B
New to me Freelander 2 SD4
Replies
4
Views
623
Nodge68
Nodge68
A
Freelander 2 i6
Replies
11
Views
413
Freddie17
Freddie17
Sierra Charlie
Freelander 2 positive battery clamp.
Replies
11
Views
1K
Freddie17
Freddie17
S
Freelander 2 egr coolant leak? Bypass? Plus oil cooler bypass?
Replies
11
Views
503
Freddie17
Freddie17
Back
Top