Rangeymad
New Member
- Posts
- 19
- Location
- Shropshire
Hi, just wondering what sort if speeds people are gettin and what rpm, my rpm seems pritty high to be honest, 50 mph is around 3000 rpm on mine, any help really appreciated :smokin:
2.5 dse what speed at what rpm
- Thread starter Rangeymad
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 58,170
- Location
- Preston Lancs.
Auto i take it. RPM at 50 with torque lockup should be below 2000. Would say you are stuck in third get it on diagnostics.
Last edited:
Rangeymad
New Member
- Posts
- 19
- Location
- Shropshire
Yes mate auto, mines struggling then, could that b the same cause why it won't go into gear sumtimes inless I put my foot to the floor then it slams in
- Posts
- 58,170
- Location
- Preston Lancs.
Doing that will not have done it a lot of good, sticky valve block, dirty oil, blocked filter, really low fluid. Damage may already have been done.
Rangeymad
New Member
- Posts
- 19
- Location
- Shropshire
Iv done the 2 services you advised me on another post changes are really smooth jus struggles to go into sum times wen cold and high rpm, starting to think new box time maybe 
- Posts
- 58,170
- Location
- Preston Lancs.
Iv done the 2 services you advised me on another post changes are really smooth jus struggles to go into sum times wen cold and high rpm, starting to think new box time maybe
Engagement of drive is manual for main drive clutch, electric for ratio clutches. Did you never put it on diagnostics? If nothing comes up on that it is mechanical, something in valve block or low oil pressure or a combination of the two.
Rangeymad
New Member
- Posts
- 19
- Location
- Shropshire
Ok cheers, yea put it on diagnostic showing no faults, any tips on next move mate if it is 1 of the 2 you mentioned are they a big job to repair
- Posts
- 58,170
- Location
- Preston Lancs.
You need someone who knows what they are doing for either. Pump is fairly simple but you need box out. By the time you have buggered about and got nowhere it may be as well to get a known good box stuck in.
Rangeymad
New Member
- Posts
- 19
- Location
- Shropshire
Ok mate thanks again, 3rd p38 this is there all a pain in the ass lol
