monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
anybody got a how to or a link to show me how to do it
tia tony
tia tony
1996 4.6 hse water pump replacement
- Thread starter monty1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hi
Its quite straght forward
I did mine in just over half an hour
The hardest bit is removing viscous fan without the special tool.
I put a screw driver flat blade near one edge of the nut holding the fan then tapped with a hammer then undo bolts scrape off old gasket fit new gasket and bolt it back up fill with coolant bleed coolant jobs a good in
Its quite straght forward
I did mine in just over half an hour
The hardest bit is removing viscous fan without the special tool.
I put a screw driver flat blade near one edge of the nut holding the fan then tapped with a hammer then undo bolts scrape off old gasket fit new gasket and bolt it back up fill with coolant bleed coolant jobs a good in
supermans_1
New Member
- Posts
- 58
and 1 thing on these that are diff from most vehicles is that if u are looking at the fan from the front of the vehicle then u need to undo it anti closc wise just as if u was undoing a standard normal bolt most cars are reverse thread but these are not
monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
thanks for the tips going to fit it today.
tony
tony
monty1
New Member
- Posts
- 143
- Location
- eston middlesbrough
all done not too bad a job at all
took me just over a hour,thanks again
tony
took me just over a hour,thanks againtony
