Search results

I know this sounds stupid but when my early series 2a wouldnt start I found I connected the battery the wrong way round, because I forgot it was positive earth. The engine turned the right way but the coil did not produce any current. Just a thought! :)

I looked at the paddocks site and they dont have any I want. One of the tyres fitted to my landy is a Deestone extra traction. Where could I get some?

Hi Does anybody know if you can get some cheap Chinese sweatshop type tires with the same tread as the 'Avon traction milage' (the ones which were origionaly fitted) tires? Thanks

Good idea, the disco's ugly as hell aswell!!

I know but it's not on the road at the moment, it's just being used for farm work and just a temporery fix would do. We are going to restore it next year hopefully

I used the hole in the middle of the brake drum which released the rust, then I just had to simply pull off the drum! I degreased the shoes (looks like the oil seal needs replacing) and the drum, put it and the wheel back on and now when I try to do an emergency stop it stops without pulling to...

Ooh!! is that what the hole at the front of the drum is then??

Ok tried the hammer and punch, diddnt work. Drilled the head off the screw but now I come to the next problem, the drum is completly stuck. I have tried slacking the adjusters right off and that diddnt work. Tried brute force and that diddnt work. Tried the hammer and that method also is not...

Couldnt you just unbolt the earth from the battery?:rolleyes:

When I got gertrude earlier this year (1965 2a) she had been stood, neglected, with her backside in a hedge since 1989, outside, and the only thing that seems to have gone rusty in one of the door tops and part of the bulkhead. And when she was bought home she started fine (with a new fuel pump...

I havent but I doubt it will work as the screw head is knackered

Ok I'll try tomorrow if the weather is good as the landy cant go in the shed because it's full of motorbike thingies

Hi Does anyone know what to do if you have a siezed brake drum screw and you can't undo it? The head is completely knackered. I have tried pluss gas and alot of other rust releasing agents, a drill, impact driver and of course since the screw is totaly flat I cannot use pliers on it. Any other...

Try the Discovery forum, this one is for the realy old late 40's to early 80's jobbies. Like they had in born free

Turned out to be a duff voltage regulator

Thanks I'll try tomorrow

When we picked up our 1965 2a the battery was discharging and we seem to have found the problem. When we took the voltage regulator lid off when all the wires were connected to the box, the points that stop the dynamo discharging the battery stuck when they were pushed as if it was like a magnet...

Ok when I took the fuel sender unit out I slowly moved the float up and when I get just before the full position the guage reads just under half full. But when I move the float just a fraction more, the guage hits the full mark

One wire goes to the fuel sender unit and two more wires coming off the same point go to the fuse box. On the other side of the fuse box that wire goes to the ignition switch

That is the heater switch