Search results

you only need small nut and bolts and as long as you put the bolt head on the door side of the gutter so it doesnt catch on the door as you open it it works a treat. :-)

I have found that after it rains I find the drivers side footwell soaking with water. After some investigating with a hose I found that due to the door top not sitting properly vertical, the rain was coming off the roof into the gutter then draining out the drain holes by the door, onto the door...

I have an oil preasure guage on the dash and a clear pipe coming from it that has been chopped off in the past. Where does the other end come out the engine? Reason I ask is it is loosing oil (yeah I know it's a series thing!) but I am guessing oil goes up the pipe to make the guage work? If the...

yeah, why not synthetic? Thats what I have been throwing in the top and spewing out the exhaust!

I took the inspection hatch of and the back plate and the nut can move a few mm before the locking tab on the washer stops it going anywhere. All was tight inc the big main cog. I checked the oil level and that was fine too. Mystery continues I'm affraid!

When you say on the main shaft, is that the same one you would undo if you were to put an overdrive on? If so, I know where that nut is. If not, then I have no idea!!! lol I didnt really get much chance to investigate the sound properly as I was just hoping I would make it home and not need the...

Yesterday I accidently started the landy in 1st gear with me foot not on the clutch. Didnt jump forward or anything though. Thought nothing of it. Took it out of gear and started lovely as normal. Pumped my flat tyre up, and jumped in to drive off. I couldn't drive away as it wouldnt go in any...

the paper gasket is shot on one of the bolt holes so needs changing. I have also gicved the rubber seal a wipe over and re fitted it all the the rubber seal looked ok with no splits etc. Put new "ep stinky" in and it runs alot smoother now. Not much oil came out the drain plug and what did come...

The oil preasure guage doesnt work and the clear ish tube coming from the dial is not attatched to anything. Where is the other end in the engine bay? I am guessing the guage works by oil going up the tube to the dial? So if nothing is connected the other end, oil comes out? Oil coming out...

did you get this sorted in the end as I want to install an inertia seat belt into my series 3. Which bits did you buy etc?

In the Landys MOT a few weeks ago I had an advisory that there was an oil leak around the rear off side brake drum. He couldnt tell if it was brake fluid or axle oil. I have stripped it down now and found the brake cylinder bone dry, so it must be the axle oil. Now, the puzzling things are...

Hello. I have the Landy below and I love driving it. I t cut the paint work the other day so looks alotmore shiny than the photo does!!! Just found this forum as I was looking for a forum with lots of series 3 knowledge. Fingers crossed I have found the knowledge!