Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. B

    cold start problem

    I will check the pump timing the week end when I have some time available. I have not changed the timing belt yet but i know the previous owner took it for regular services to the agents. I will check the tensioners as well cause i can hear the one tensioner is not so nice any more. where does...
  2. B

    cold start problem

    Just tested that as well, light stays on for 4 seconds after dash light goes of and goes of when enjin runs.
  3. B

    cold start problem

    it has done about 185000 km, the mechanic next door thinks that the fuel flows back to through the pump and i must put a none return valve on the inbound fuel line.
  4. B

    cold start problem

    i have a 99 freelander 2.0d, when cold you have to crank it for about 20 to 30 sec and glow it a couple of times before it starts. when it starts there is a lot of white smoke. i replaced injectors about a year ago and and glow plugs last week but it still does the same:doh::doh::doh::doh: when...
  5. B

    Freelander not starting and...

    I've got a 99 freelander 2.0D battling to start when cold but when warm it starts first turn. replaced glow plugs and replaced injectors about a year ago. lots of white smoke when it starts after about 20 seconds of turning. please advise?:doh::doh::doh:
  6. B

    question about abs and converting to 2wheel drive

    Removing the rear prop does not affect your abs at all, you have one of 2 problems on the sensors or the ABS unit is faulty. remove all your sensors and clean them with very fine sand paper, replace and make sure the gap between the sensor and the ring is not more than 2mm, reset the ABS...
  7. B

    Next on the list........VCU

    i also have an old freelander, the 99 2.0d 3dr. my vc unit seized up totally, took it out drilled 4 holes opposite each other in it and used a big wrench to turn it. it started turning again. welded the holes shut and replaced the hanger bearings. it worked for me. easiest way to test the VC is...
Back
Top